Catalogs >
Decoustics >
Custom Curved S-shaped or wave panel

Custom Curved S-shaped or wave panel
2Pages

Catalog excerpts

Custom Curved S-shaped or wave panel - 1

Ceilings Custom Curved S-SHAPED OR WAVE PANEL Description Decoustics acoustical panels provide architects and designers with wide latitude in curvilinear design. S-Shape or Wave precurved ceiling panels are a unique way to create dramatic visual expression without the problems of sound focussing and reflection normally associated with traditional hard surface finishes such as gypsum board, plaster, glass reinforced gypsum (GRG), fiber reinforced polyester (FRP), or wood. Panels consist of two-dimensional pre-curved units that utilize one or two radii (inside and outside) throughout the curve. Interesting visuals are possible due to the distinctive shapes that can be achieved with these panels. A variety of mounting methods can be employed depending on plenum access requirements, available substrate, plenum clearance, and panel joint preference. e.g. defined, closed reveal or open reveal. furring channel Suspension (by others) curved track Panel clip, screwed to or engaged on furring channel Panels Typical joints All Decoustics panels are custom fabricated and offered in a variety of types, sizes, geometric shapes, ellipses, vaults, acoustical domes, thicknesses, and finishes. Limitations Minimum radius is currently 30" (760 mm). Contact Decoustics regarding availability of smaller radii. Design Considerations Mounting Methods Pre-curved S-Shape or Wave panels can be installed using the following Decoustics ceiling systems: 1. Span (Perimeter supported, upward accessible, with defined, closed (refer to data sheet “Custom Curved - Vault Shape” for diagram details) reveal or open joints). 2. Direct Mount (progressively accessible, only with defined, closed reveal or open reveal joints). 3. Direct To Suspended Frame/Grid (progressively accessible with defined, closed reveal or open reveal panel joints). 4. Suspended Reveal (Floating panels, with open reveal joints). 5. Accessible Reveal ( upward accessible, with minimum reveal joints). 6. Ceilencio Custom (downward accessible, with defined joints). 7. Lay-In (upward accessible, with exposed suspension grid). Note: Field cutting of panels is possible but not recommended. The panels alone can form the S-Shape or Wave without the need for a curved substrate. If, however, a curved substrate already exists, panels can be directly mounted to it. Depending on panel radius and thickness, exposed darting at corners may result with some fabric finishes. Darting will always be visible with vinyl finishes. Contact Decoustics for specific information. It is recommended that curved panels have joints where the radius changes from inside to outside. Extruded aluminum metal edges are preferred for joint detail alignment and handling. Contact Decoustics for best finishes to use with specific lighting. …cont’d

Open the catalog to page 1

Custom Curved S-shaped or wave panel - 2

Ceilings Note: The information provided in this Data Sheet is accurate to the best of our knowledge at the time of printing. However, we reserve the right to make changes when necessary without further notification. Suggested applications may need to be modified to conform with local building codes and conditions. We cannot accept responsibility for products that are not used, or installed, to our specifications. Please refer to our website for most current data. Custom Curved S-SHAPED OR WAVE PANEL Note: Only handle panels wearing clean, lightweight, white gloves during installation....

Open the catalog to page 2