ECONOMICAL DOMESTIC JET ASSISTED PRESSURE SYSTEM Ideal for small/average size homes, cottages, weekenders, caravans and boats (240V A.C. power), domestic water supply, pressure boosting and automatic water transfer. The unit features a TEFC corrosion resistant motor driven by a single stage, jet assisted centrifugal pump and includes a built in pressure accumulator with a "Supercell" 8P tank which provides 3 litre draw-off. • Manufactured from quality corrosion resistant materials • Motor and pump designed for frequent starts • Discharge may be rotated through 180° - makes plumbing easier • Quick and easy installation • Low maintenance • Easy to service if required • Every pump is performance and pressure tested in our factory to ensure quality and reliability MOTOR • Davey manufactured • High quality purpose built 2 pole IP55 Davey pump motors with: Choice of 220/240 volt, 50/60Hz, 2850rpm or 110/115 volt, 60Hz, 3420rpm to suit almost every supply voltage • Class F insulation • Permanently split capacitor design for dependable and frequent starting every time • Double contact C3-HTG rated sealed ball bearings for longer life • In-built thermal overload protection for long motor life and protection against motor damage due to jamming • Feet on motor shell provide outstanding life even when installed on wet surfaces PRESSURE TANK • Captive diaphragm design • Heavy duty Butyl diaphragm meets health requirements for potable water applications • Deep drawn steel shell with appliance like 2 part paint finish

OPERATING LIMITS ELECTRICAL DATA MATERIAL Glass filled polycarbonate Glass filled nylon 304 stainless steel Delrin 304 stainless steel Ceramic Carbon Nitrile rubber 304 stainless steel Nitrile rubber Acetyl Glass filled noryl Glass filled polypropylene Marine grade aluminium Baked polyester Steel Epoxy primer with polyurethane epoxy finish Butyl rubber Potable grade virgin polypropylene Stainless Steel INSTALLATION AND PRIMING • On installations with suction lifts over 1m, a good quality foot valve should be fitted to avoid loss of prime. In this case the check valve inside the pump should be...