Steel Rolling Towers

STEEL ROLLING TOWERS SYS-FAST STEEL ROLLING TOWERS The rolling towers system SYS-FAST is characterized by offering all the advantages of the modular scaffolding system and it is fully compatible with this system, too. It also has a wide range of high-strength and low weighted frames. The main characteristics are: • Excellent balance between weight and performance. Frames manufactured with structural steel tube Ø 48 mm in diameter, with ledgers every 50 cm. • Simplicity and speed when assembling. A reduced number of references facilitate the understanding of the system keeping versatility to adapt...

Round tube 0 48 mm steel uprights available in 135 cm width. Ledgers every 50 cm provide system versatility in the height of the platforms. Available in the following heights: 1 m and 2 m. They have rosettes for connecting the ledgers and the diagonals of the modular scaffolding MEKA 48 every meter as well as a galvanized snap pin. Hot dip galvanized, minimum thickness of 75 microns. Manufactured with 0 48 mm pipe, they have articulated locks on both ends. They full-fill the function of bracing the frames and they also act as stabilizers in very high towers. Hot dip galvanized.

STEEL ROLLING TOWERS FIXED STEEL PLANKS Planks manufactured in accordance with the EN 12811 standards. An extremely resistant perforated working surface manufactured with antislip grooves. The 2 welded tubes make them easy to handle. Width: 30 cm. Hot dip galvanized and with a minimum thickness of 75 microns. They comply with the 12810-2 fall arrest system requirements.

j SCREW JACK CASTERS AND SCREW JACK BASE Swivel casters with a brake system, available for different load capacities. The screw jack base 1.0 m with 2 levers is used for stabilizing towers, mainly combined with brackets or stabilizers composed by a base collar, a ledger and a diagonal brace. Cold galvanized. Description Weight (kg) Max. Reg. (cm) Part No. j SCREW JACK HOLDER The jack holders allow holding the casters of the towers to make the lifting operations safely. They connect to the vertical tube of the frame with a clamp and have two handles made of round bars to hold the caster handle....

STEEL ROLLING TOWERS ASSEMBLY PROCEDURE - SYS-FAST (5-PLUS) Insert the casters at the bottom of the 2 m frame. Leave the frame on the floor and face the casters onto the tube. The casters must have the brake device activated. Then, while an operator holds the frame upright, the other places a bubble level and verifies the horizontal of the frame transom regulating the handles of the casters. Then, assemble the jack holders at the lower ends of the frame. You must have a ratchet to tighten the clamp nut. Hit the pin of the rosettes with a hammer to connect the 2 m ledgers as well as the 2 m guardrails...

• Maximum work height: 6.60 m (for greater heights, please contact our Technical Department). • Working surface area: 1.35 x 2 m = 2.7 m2. • Working load: 2kN /m2 (Class 3) , EN 1004:2006. • Instruction manual in compliance with EN 1298:1996. SYS-FAST - CHARACTERISTICS (*) Heights with the caster spindle fully extended and, in brackets, the height with the caster spindle fully retracted.

Ctra. Santa Bárbara - La Sénia, km 4,6 Tarragona - SPAIN Modular scaffold MEKA 48 Aluminium rolling tower ALU 50 Sectional scaffold SECUS Rolling tower SYS-FAST Ladder frame scaffold Rolling tower MEKA 48 European frame scaffold DINO 48 Multipurpose tower European frame scaffold FREE 48 Stages, ramps & grandstands. Access towers