CTS Cement | Professional Cement Products Rapid Set® Cement All® Datasheet HIGH STRENGTH, NON-SHRINK GROUT Multi-Purpose Repair Material Highlights: • FAST Sets in 15 minutes; structural strength in 1 hour • STRONG 3 times stronger than most concrete • DURABLE Formulated for long life in critical applications • EXCELLENT BOND Superior adhesion to concrete, stone, brick, block, stucco and more • STRUCTURAL For repair and new construction • MULTI-PURPOSE Use for concrete repair, grouting, anchoring, casting, underlayment and more MANUFACTURER: CTS Cement Manufacturing Corp. 11065 Knott Ave., Suite A Cypress, CA 90630 Tel: 800-929-3030 Fax: 714-379-8270 Web: www.ctscement.com E-mail: [email protected] PRODUCT NAME: Rapid Set® CEMENT ALL® DESCRIPTION: Rapid Set CEMENT ALL is a high-performance, fast-setting, multi-purpose concrete repair material and non-shrink grout. Durable in wet environments, CEMENT ALL is a blend of Rapid Set hydraulic cement and specially graded fine aggregates. CEMENT ALL is non-metallic and no chlorides are added. Mix CEMENT ALL with water to produce a workable, high quality material that is ideal where rapid strength gain and high durability are desired. CEMENT ALL sets in 15 minutes and achieves structural strength in 1 hour. RECOMMENDED USE: Use CEMENT ALL for general and structural concrete repair, doweling and anchoring, industrial grouting, formed work, vertical and horizontal trowel applications. CEMENT ALL is ideal for airport, highway, industrial and marine applications. ENVIRONMENTAL ADVANTAGES: Use CEMENT ALL to reduce your carbon footprint and lower your environmental impact. Production of Rapid Set cement emits far less CO2 than portland cement. Contact your representative for LEED values and environmental information. APPLICATION: Apply CEMENT ALL in thicknesses from featheredge to 4" (10 cm). For heavy loads and vehicle traffic, minimum thickness will vary. Not intended for high heat applications above 300°F. For deeper sections, use Rapid Set® Mortar Mix or Rapid Set® Concrete Mix. For overlay applications, a minimum one test section should be prepared to evaluate the suitability of the materials and procedures. SURFACE PREPARATION: For repairs, application surface shall be clean, sound and free from any materials that may inhibit bond, such as oil, asphalt, curing compound, acid, dirt and loose debris. Roughen surface and remove all unsound material. Apply CEMENT ALL to a surface that is thoroughly saturated with no standing water. MIXING: The use of a power-driven mechanical mixer, such as a mortar mixer or a drill-mounted mixer, is recommended. Organize work so that all personnel and equipment are in place before mixing. Use clean potable water. CEMENT ALL may be mixed using 3 to 5 quarts (2.8 to 4.7 L) of water per 55-lb (25-kg) bag. Use less water to achieve higher strengths. Do not exceed 5 quarts (4.7 L) of water per bag. For increased fluidity and workability, use Rapid Set® FLOW Control® plasticizing admixture from the Rapid Set® Concrete Pharmacy®. Place the desired quantity of mix water into the mixing container. While the mixer is running, add CEMENT ALL. Mix for the minimum amount of time required to achieve a lump-free, uniform consistency (usually 1 to 3 minutes). Do not retemper.

HIGH STRENGTH, NON-SHRINK GROUT Multi-Purpose Repair Material PLACEMENT: Rapid Set® CEMENT ALL® may be placed using traditional construction methods. Organize work so that all personnel and equipment are ready before placement. Place, consolidate and screed quickly to allow for maximum finishing time. Do not wait for bleed water. Apply final finish as soon as possible. CEMENT ALL may be troweled, floated or broom finished. On flat work, do not install in layers. Install full-depth sections and progress horizontally. Do not install on frozen surfaces. Use a method of consolidation that eliminates...