Crestron MP-AMP30 Media Presentation Audio Amplifier Operations & Installation Guide

This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON Regulatory Compliance As of the date of manufacture, the MP-AMP30 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Federal Communications Commission (FCC) Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference and (2) this device...

Media Presentation Audio Amplifier Contents Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC. 6917B

Crestron MP-AMP30 Media Presentation Audio Amplifier The Crestron® MP-AMP30 provides a convenient, low-cost audio amplifier solution for a variety of applications. A perfect complement to the entire Media Presentation line from Crestron, it features a compact surface-mountable design that installs virtually anywhere without requiring an equipment rack. High-efficiency Class D circuitry delivers 15 Watts per channel to drive one or two pairs of 8-Ohm speakers, or a single pair of 4-Ohm speakers, making it ideal to support stereo speakers at the front of a room or mono speakers in the ceiling....

Media Presentation Audio Amplifier Crestron MP-AMP30 Installation and setup of the MP-AMP30 is simple. Detachable output connectors facilitate the termination of speaker wiring up to 16 gauge. RCA inputs connect directly to the line output of a video projector or display, audio processor, mixer, or AV switcher. Rotary controls provide for adjusting the overall speaker volume, as well as bass and treble. For quiet environments, loudness compensation is employed by setting the volume control below the center detent position. Applications Specifications for the MP-AMP30 are listed in the following...

Crestron MP-AMP30 Media Presentation Audio Amplifier Physical Description This section provides information on the connections, controls and indicators available on your MP-AMP30. MP-AMP30 Front View Operations & Installation Guide - DOC. 6917B Media Presentation Audio Amplifier: MP-AMP30 • 3

Media Presentation Audio Amplifier 4 • Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC. 6917

Crestron MP-AMP30 Media Presentation Audio Amplifier Connectors, Controls & Indicators Interface connectors for AUDIO OUT ports are provided with the unit. Operations & Installation Guide - DOC. 6917B Media Presentation Audio Amplifier: MP-AMP30 • 5

Media Presentation Audio Amplifier Crestron MP-AMP30 Installation Mount the MP-AMP30 to a flat surface near the audio source equipment, using four screws (not supplied). Channel Stereo Audio Input Input Power Power Supply Before applying power, do the following: 1. Make sure the shunt jumpers are properly positioned for stereo (ST) or mono (MO) audio. (Refer to diagram on unit.) 2. Connect all input and output cables (refer to the above illustration). 3. Set the BASS and TREBLE controls to their default center detent positions, and set the VOL control to a low (counterclockwise) position. Apply...

Crestron MP-AMP30 Media Presentation Audio Amplifier Crestron MP-AMP30 Media Presentation Audio Amplifier Troubleshooting The following table provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. NOTE: Any momentary short, misconnection, or overload will cause the protective circuits to turn the unit off. Once the fault is cleared, the unit should automatically recover. Should it not, recycling power will ensure full recovery. Further Inquiries If you cannot locate specific information or have...

Media Presentation Audio Amplifier Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phone number of contact person, RMA number and return address. Products may be returned for credit, exchange or service...

Media Presentation Audio Amplifier This page is intentionally left blank. Operations & Installation Guide – DOC. 6917B Media Presentation Audio Amplifier: MP-AMP30 •

Media Presentation Audio Amplifier This page is intentionally left blank. 10 • Media Presentation Audio Amplifier: MP-AMP30 Operations & Installation Guide – DOC. 6917

Media Presentation Audio Amplifier This page is intentionally left blank. Operations & Installation Guide – DOC. 6917B Media Presentation Audio Amplifier: MP-AMP30 • 1

Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 Tel: 888.CRESTRON Fax: 201.767.7576 www.crestron.com Operations & Installation Guide - DOC. 6917B (2025921) 05.10 Specifications subject to change without notice.