trails technical product info exterior pavers trails technical product info trails concrete pavers are dimensionally accurate and can be simply mortar set, sand set or pedestal set in accordance with standard masonry practices depending on your project needs. once installed the surface should be thoroughly cleaned and then sealed with a quality penetrating sealer such as drytreat stain-proof. cleaning pads and sealer are available from concrete collaborative.

technical summary ivory — 64 taupe — 39 ebony — 11 alabaster — 82 chestnut — 47 coal — 20 blonde — 73 shale — 44 fossil — 18

trails concrete pavers are dimensionally accurate and can be simply mortar set, sand set or pedestal set in accordance with standard masonry practices depending on your project needs. once installed the surface should be thoroughly cleaned and then sealed with a quality penetrating sealer such as drytreat stain-proof. cleaning pads and sealer are available from concrete collaborative. - concrete pavers are similar to natural stone tiles (rectified/uncalibrated) to suit our stated caliber and size range which vary less in facial dimension than natural stone. - edges are mechanically cut to achieve...

trails technical product info 5 . insta lla tio n m or ta r se t - use laticrete 254r platinum rapid or approved alternate. - use laticrete 253 in heat over 95 degrees. - back-butter each paver to ensure 100% coverage and adhesion. - blend pavers f rom several crates to enhance natural variations. - maintain a grout joint no less than 0.5% of long side of paver. - grout pavers using quality sanded grout such as laticrete permacolor, an impregnating or grout release prior can help. - be diligent in removing any adhesive or grout f rom surface before drying. - also follow adhesive and grout manufacturer’s...

- wet-scrub pavers with a floor machine using warm water and htc twister pad red. - for more aggressive scrub-light duty masonry cleaner like prosoco sure kleanscrub and bristle brush. - work in sections and be diligent in removing dirty water before drying. - apply 2-3 thin coats of drytreat stain proof sealer or (owner's preferred sealer) following manufacturer's instructions. - wipe-off excess sealer using a microfiber to maintain a natural finish. - allow appropriate cure time for sealer prior to use. - if you have any questions please contact our technical team: [email protected]...