rivi technical product info technical product info bondi terrazzo basins are provided un-sealed. 3 coats of polishguard sealant should be applied prior to f irst use. bondi should be installed on a surface mount. bondi should be adhesive-f ixed to the substrate. bondi should be plumbed with standard 1-1/4” pipe and drain. due to the inherent nature of concrete and natural aggregates, no two basins are exactly alike, they will exhibit variations in tone, aggregate size and distribution. it is a feature of the material. 855.268.0800 | concrete-collaborative.com | [email protected]
Open the catalog to page 1bondi technical product info install weight silicon / pl or construction adhesive eased/f inished 3 coats polish guard use warm clean water and ph neutral (non-acidic detergent high density food safe shower rated heavy traffic tonal variation scratch resistant
Open the catalog to page 2bondi technical product info installation 1. bondi concrete basins are intended to be surface mounted to a suitable substrate or countertop using a clear silicone caulk or construction adhesive. bondi does not require screws. 2. wipe the underside of the sink and receiving counter surface clean in preparation adhesion. 3. with sink upside-down, run a bead of silicone around the outer diameter holding back about 1/4” from the edge. run a bead of silicone around the inner diameter of the drain opening as well, ensure there are no gaps in the silicone bead. 4. set sink into final position and press...
Open the catalog to page 3bondi technical product info
Open the catalog to page 4