Cleaner for waxed surfaces and degreaser for the preparation of oily and tropical woods before finishing application. Quick action within a few minutes. Guarantees an excellent adhesion of all types of finishes for parquet floors and woodwork. Does not stain wood. All types of sealed parquet floors, exuding and exotic wood. APPLICATION EQUIPEMENT : Ready to use Cleaning equipment : Water. TECHNICAL CHARACTERISTICS : AFNOR Classification Product outside the scope of the directive. VOC in indoor air (28d) Density at 20°C Viscosity at 25°C Solvent Flash point Conservation PACKAGING : N/A 1,04 ± 0,05 2,2 ± 0,2 Poises Water N/A. Non flammable product. 24 months in closed original packaging (protected from heat and freezing) 1L HEALTH AND SCURITY : Safety data sheet available on www.quickfds.com APPLICATION ADVICE : Shake before use. Apply with a brush abundantly and regularly. Allow a few minutes for acting. Removing oil : Clean with a steel wool n°3. Degreasing : Wipe with a cloth until it is clean. Two successive cleanings may be necessary. Rinse with warm water. Allow ±48 h for drying before finishing. RECOMMENDATIONS : Always remove oil before sanding parquet floors. Do not apply at a temperature of less 12°C, and in very hot weather The recommendations featured in this data sheet are designed for experienced individuals with the required skills. They are based on tests carried out in compliance with applicable conventional standards and with NF standard P 74-201 1 and 2 DTU reference 59.1 (09/94). These recommendations are for illustration purposes only and can under no circumstances replace a requirement specific to the project. Consequently, COMUS shall not be held liable for any damage resulting from works carried out at the user's own risk. COMUS : BP 19 - St Germain Lès Arpajon - F-91 291 Arpajon - Fax: +33 (0)1 60 84 04 81- www.solutions-comus.com VERSION OF JULY 2015. SUPERSEDES ALL PREVIOUS VERSIONS