GMT2020

GMT2020
1 / 11 PagesView full catalog

GMT2020

Product catalog summary
Reliability Test Summary
  • Mechanical Strength: The product is tested with a hammer spring impact energy of 0.7J to ensure durability.
  • IP Rating: Achieves IP67, providing protection against dust and water ingress.
  • Winding Test: Conducted at -25℃ with a 60N pull, winding 10 times to test flexibility and resilience.
  • Cold Bend and Impact Tests: Cold bend test at -15℃ for 16 hours and cold impact test with a hammer drop from 100mm height.
  • Insulation and Electrical Strength: Insulation resistance must be ≤ 2MΩ at 500V, with electrical strength tested under various conditions.
  • Bending and Torsion Tests: Includes 100 cycles of bending and 3000 cycles of twisting to ensure mechanical endurance.
  • Disassembly and Assembly: Repeated 10 times to test product integrity.
  • Temperature and Humidity Tests: High temperature at 80℃ and low temperature at -40℃ for 168 hours each; humidity and salt spray tests at 60℃, 85% RH, and 5% salt concentration for 24 hours.
  • IK and Lifetime Aging Tests: Impact tests and aging tests conducted at 35℃ for 6000 hours to assess long-term durability.
  • Switch Test: Operated 10 seconds on/off, repeated 10,000 times to ensure reliability.
  • Safety Standards: Complies with IEC 60598-1 and IEC 60598-2-21 standards.
Precautions
  • Avoid physical damage such as trampling, excessive distortion, and violent stretching.
  • Use an isolated power supply with less than 5% ripple for optimal performance.
  • Maintain a 20% power margin to ensure adequate voltage supply.
  • Prevent electric shock by not touching AC power terminals when powered.
  • Ensure correct polarity and voltage to prevent damage.
  • Avoid scratching, twisting, and irregular bending during installation.
  • Do not bend the light strip in an arc with a radius less than 90mm to prevent damage.
  • Exceeding specified length can lead to overload and uneven brightness.
  • Avoid prolonged exposure to the light-emitting surface.
  • Installation, disassembly, or repair should be performed by professionals only.
  • Use silicone sealant instead of acidic or alkaline adhesives.
  • IP67 products are not suitable for underwater use in swimming pools.
  • Confirm color consistency before use due to potential structural differences.
  • Use professional cutting tools and seal products after cutting to prevent exposure.
  • Maintain consistent environmental conditions to prevent color changes.
See more

Catalog excerpts

GMT2020-1

AOLORS ^ Linear Lighting

 Open the catalog to page 1
GMT2020-2

Features Light source: Adopting dedicated and outdoor-specific LED, stronger reliability for outdoor application; Finished product ANSI SDCM<5; • Structure: New anti-tension structure, Integrated anti-tension silicone extrusion process, against internal stress and external tension; Double-layer circuit conductive, double power supply guarantee, broken boards without power; • Product applications: outdoor illumination, architectural facade lighting; IP67 • Product certification: CE,UKCA • Working/storage temperature: Ta: -25~50°C / 0~60°C • 5 years warranty, life span > 60000 hours. [Basic Parameters]...

 Open the catalog to page 2
GMT2020-3

【Basic Parameters】 Model Rated Maximum power power (w/m) (w/m) Standard Length Cutting Unit Note: 1. The above parameters are tested based on 1m/3.28ft standard products; 2. The luminous flux is allowed to have an error range of -15%; 3. The above parameters are typical values; 4.※RGBW/DMX-RGBW should be used in -20℃~45℃ ambient temperature if four colors are used at the same time. 【Light Distribution】 Flux out:678.2 lm Light distribution Note:The Curves indicate the illuminated area and the average illumination when the luminaire is at different distance. Effective average illuminance Note: The...

 Open the catalog to page 3
GMT2020-4

【Product mechanical parameters】 · IP67 molded end cap (ENP) Bottom *RGB/RGBW/DMXSide exit wires have a dark area of about 2cm

 Open the catalog to page 4
GMT2020-5

Accessories Picture quantity net Per box Gross /case weight net weight Box Size Order m°ael (PCS) (kg) weight (kg) (mm) Aluminum clip Size: L1000*W22.6*H24.7mm with screw Size: L25*W22.6*H24.7mm with screw Size: L1000*W23.2*H45mm with screw Size: L25*W23.2*H45mm with screw suitable for monochromatic led strip Wire lengths are optional: 0.25M/0.5M/2M suitable for monochromatic led strip Wire lengths are optional: 0.25M/0.5M/2M suitable for monochromatic led strip Wire length 150mm suitable for RGB led strip Wire lengths are optional: 0.25M/0.5M/2M E-mail:[email protected] www.colorsled.com

 Open the catalog to page 5
GMT2020-8

【Product Wiring Schematic】 POWER Black: + Red: R Green: G Blue: B RGBW Controller Black: + Red: R Green: G Blue: B White: W A/DAT+ B/DAT- ADDR/PI

 Open the catalog to page 8
GMT2020-9

【Packaging Solutions】 · standard packaging 1 Voltage: Power(Typ): Color/CCT: CRI: Lumen: IP: SO: LIGHT SOURCE ITSELF without IP Process cover 4.USE ONLY WITH CLASS 2 POWER UNIT. CAUTION: THE MOUNTING MEANS PROVIDED WITH THIS LUMINAIRE HAS NOT BEEN EVALUATED FOR RELIABILITY. IF INSTALLED WHERE FAILURE OF THE MOUNTING MEANS COULD CAUSE INJURY TO PERSONS OR DAMAGE TO PROPERTY BEOW , SUPPLEMENTAL MEANS OF SECUREMENT SHOULD BE CONSIDERED. CAUTION: 1. SUITABLE FOR CABINET USE ONLY. 2.SUITABLE FOR OPERATION IN AMBIENT NOT EXCEEDING 45°C. 3.SUITABLE FOR DAMP LOCATION. GMT2020 Voltage: Power(Typ): Color/CCT:...

 Open the catalog to page 9
GMT2020-11

· Please use an isolated power supply to drive the LED light bar, and the ripple of the constant voltage source is less than 5%. Do not use resistance-capacitance step-down, non-isolated power supplies to drive the LED light bar. · In actual applications, the power supply should reserve a margin of 20% (it is recommended to use only 80% of the power) to ensure sufficient voltage to drive the product. · Please operate carefully, do not touch the AC power terminal when the power is on to prevent electric shock. · Pay attention to the positive and negative poles of the power cord, and do not connect...

 Open the catalog to page 11

All COLORS LIGHTING catalogs and technical brochures

  1. C8168SWW

    4  Pages

  2. C8120-24V-5MM

    4  Pages

  3. GMT2020L

    8  Pages

  4. LE40G

    5  Pages

  5. CATALOG 2020

    209  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.