Programming & Operating Instructions POI-2/4/5K-0209 CODELOCKS LLC 2930 - B College Avenue Costa Mesa CA 92626 USA CODELOCKS LTD Castle Industrial Park Kiln Road, Newbury Berkshire RG14 2EZ UNITED KINGDOM

T he factory set Master Code is #1234. This should be changed immediately after installation (see program 10). T he Master Code and optional Sub-Master Code always start with the # prefix. This puts the lock into Programming Mode. hen the Master or Sub-Master Code W is entered 3 times consecutively without performing a programming function, a penalty time of 10 seconds is activated. This feature is to discourage the casual use of Master Codes as User Codes. T he length of the Master Code determines the length of the User Code and the Sub-Master Code. If the Master Code is changed to another of...

CODELOCKS CL4000 AND CL5000 ELECTRONIC LOCKS REMOVAL OF FRONT-LOAD CYLINDERS TO CHANGE KEY BY PASS FUNCTION, TO REPIN CYLINDERS, OR TO REPLACE WITH CYLINDERS BY A DIFFERENT MANUFACTURER 4. Replace the tailpiece, hold clockwise and remove cylinder from boss. If intending to use a cylinder by a different manufacturer it is advisable to confirm beforehand that the new cylinder will fit the boss. Note that the CL5000 uses a 6 pin screw-cap cylinder. The CL4000 use a 5 pin cylinder. cylinder. Hold down the control pin in the end of the cylinder and unscrew the cap. down the control pin and screw the...

First Master Code *Code change the3factory consecutively #1234 – see programa10. If the Master or Sub Master is entered times without performing programming function, a penalty time of 10 seconds is activated. Note: n the CL2000 and CL4000 locks the at the bottom of the keypad acts as the # button. O The Master Code and Sub-Master Code MUST always start with #. Codes can only be the same length as the Master Code. A or in the Key Sequence below indicates LED illumination. IF ENTERED, A SUB-MASTER CODE CAN BE USED INSTEAD OF THE MASTER CODE FOR ALL PROGRAMS EXCEPT PROGRAMS 10 AND 12. ENTER NEW...