Catalogs >
Clearwater Baths >
Formoso Petite

Formoso Petite
2Pages

Catalog excerpts

Clear Stone Baths Parts supplied: Important • Please unwrap the bath and check it carefully to ensure it has not been damaged during handling or transport. • Please check that all parts have been supplied. • Assemble bath on a mat to protect against damage to the bath surface. • Store the bath in a safe place until you begin installation. • Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area. • This installation guide does not include details of waste connection; final decisions about installation of waste connection should be taken by a suitably qualified person. Please place your product Manufacturers identification number Identification Number here and keep this XXXXXXXXXXX paperwork in a safe In the event of after place as you will sales requirements need this if a problem please quote this number. occurs with your product. Do NOT overtighten the waste as this may cause long term damage to the bath. We recommend to use a torque wrench to tighten the waste by using a torque force between 25 Nm and 50Nm. 1x Care and Maintenance The below instruction is for a fine scratch or slight mark on the surface. If the scratch or mark is too deep, then a Clearstone Repair Kit CRK will be necessary. If using the Repair Kit, follow the instructions supplied with the Repair Kit. For a fine scratch or a slight mark, use a 1500 grade sand paper, gently sand the area with water. For best results, limit sanding to the smallest possible area around the scratch. Re-polish the surface afterwards using a neutral polishing compound or toothpaste. It may be possible to polish very fine scratches away without using abrasive papers: scrubbing gently with a soft brush or plastic pad (not metal scouring pad) and a mildly abrasive cream cleaner. Afterwards scrub the whole area with plenty of clean water and re-polish as before. Everyday cleaning We recommend a non-abrasive bathroom cleaner. Warning Never use cleaners / bleach products, caustic soda and or ethyl alcohol (for example Lysoform or other specifically manufactured WC bowl cleaners. In case of contact rinse immediately with water. Please note that hair dye/colouring may de-colour your basin. Avoid using any strong dye or colour in or near your basin. Under floor access required for plumbing of bath waste. Waste connection is dependant on the site situation; final decision about installation of waste connection should be taken by a suitably qualified perso

Open the catalog to page 1

Place the bath on two wooden blocks over the waste connections. Connect the waste. Fill the bath with water and check for leakage. 4x Place the wedges in position.

Open the catalog to page 2