1. Catalogs
  2. CBG Composites
  3. CBG-Basalt-Fiber chops

CBG-Basalt-Fiber chops

CBG-Basalt-Fiber chops

Product catalog summary
Product Overview:
CBG-Basalt-Fiber chops are a high-technology material derived from natural basalt rock. They are used as reinforcing additives in various matrices to enhance composite material strength. Key features include high strength, corrosion resistance, chemical resistance, high electrical resistance, and low thermal conductivity.
Specifications:
  • Material: Basalt rock
  • Monofilament diameter: 9-17 μm
  • Moisture content: < 1%
  • Application temperature range: -250ºC to +1100ºC
  • Maximum application temperature: 1300ºC
  • Loss weight at ignition: 0.2% to 2.0%
  • Chops length: 6 mm to 72 mm
Application Areas:
Primarily used for reinforcement in the construction industry and architecture.
Storage and Transportation:
  • Store in a dry place in original packaging with air humidity not exceeding 80%.
  • Transport using covered vehicles to prevent moisture absorption.
Processing and Safety:
Follow general occupational health and safety instructions during handling and storage.
Note:
The information reflects the state of knowledge at the time of printing and is subject to change. For the latest data, refer to the most recent edition of the data sheet.
See more

Catalog excerpts

CBG-Basalt-Fiber chops-1

Carbon Basalt Glas Chopped basalt fiber is a modern high-technology material which provides high strength, good mechanical properties, large thermal range of application. It is produced by cutting of continuous basalt roving into sections of required equal length. It is used as a reinforcing additive in various organic and inorganic matrices to increase the strength of the composite material. ✓ 100% natural origin ✓ ultrastrength material ✓ corrosion-resistant ✓ chemical resistance Processing and storage ✓ When handling and storing the product, the general occupational health and safety instructions must be observed ✓ Storage in a dry place in original packaging, air humidity content should not exceed 80% www.cbg-composites.de [email protected] CBG Composites GmbH Egerpohl 2 D-51688 Wipperfuerth / Germany Tel: 02267-67-0 Fax: 02267-67-222 The technical information on our products reflects the state of our knowledge at the time of printing. Therefore, the latest edition of the data sheet should always be used, as our experience and knowledge are constantly evolving. In case of doubt please contact us. The application shown is only exemplary and may vary in individual cases. It is therefore not relevant for liability. Our general terms and conditions apply, which can also be found on our homepage.

 Open the catalog to page 1
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.