The expansion joint sealing strip The expansion joint sealing strip SELF-ADHESIVE, BITUMEN TOLERANT EXPANSION-JOINT SEALING STRIPS SELF-ADHESIVE, BITUMEN TOLERANT EXPANSION-JOINT SEALING STRIPS RESIFLEX® SK is a self-adhesive, expansion joint sealing strip based on EPDM synthetic rubber and contains integral glass-fibre reinforcement in the outer edge areas. RESIFLEX® SK is not reinforced in the expansion zone. The underside is equipped with a self-adhesive, polymer-modified bitumen layer, protected by a detachable release film. PRODUCT PROPERTIES • ESIFLEX® SK can be permanently bonded with all R RESITRIX® waterproof membranes. Connection with other material types may only be carried out after consultation with our Technical Department. • RESIFLEX® SK meets DIN 4102, Sheet 1 (Building Material Class B2) and Class E acc. to DIN EN 13501-1. • ESIFLEX® SK is CE–certified acc. R to DIN EN 13956 and DIN EN 13967. APPLICATIONS • xpansion-joint sealing strips for the construction of E expansion joints, particularly in the area of unused roof constructions and those that can be walked on, as well as components that touch the ground. • ESIFLEX® SK can also be used in the transition zones R of horizontal to vertical joints and within valley areas. RESIFLEX® SK cannot be used in areas where loose and fixed flange constructions are required. RESITRIX® Product catalogue

PHYSICAL PROPERTIES OF THE REINFORCED EXPANSION AREAS: MATERIAL PROPERTIES INSTALLATION INSTRUCTIONS Ideally, RESIFLEX is arranged on the roof membrane to be installed, whereby the roof membrane is interrupted above the joint. RESIFLEX® SK is self-adhesive and is applied after full-surface priming using FG35 and an appropriate airing time. RESIFLEX® SK must be hot-air welded to a width of at least 40 mm on the edge of the expansion-joint sealing strip. The non reinforced expansion zone is above the joint and remains unbonded. If required as a result of construction progress, RESIFLEX® SK can...