Pipe sleeve (35-100 mm) EPDM SHAPED PARTS FOR SEALING CIRCULAR ROOF PENETRATIONS EPDM shaped part for slipping over and sealing in roof penetrations with a round cross-section and diameters of 35 to 100 mm. The connecting collar consists of a circular piece of RESITRIX® SK W Full Bond with a diameter of 50 cm. APPLICATIONS • ll RESITRIX® seals without primer A • iquid-applied plastic systems that do not L contain softeners using FG 35 surface primer • f your application is not stated, please I contact our Technical Department RESITRIX® Product catalogue

work preparation The surfaces to be bonded must be dry, clean and free from dust and grease. installation The connection collar is tightly bonded with the roof sealing using hot-air welding only. The weld width is at least 4 cm. Before the sleeve can be slipped on the roof penetration, the upper side must be cut or reduced to fit correctly. The correct cutting point is determined as follows: First turn the pipe sleeve and then place it in the penetration. Mark the point at which the sleeve stops flush with the roof penetration. The cutting point is 2 cm above this mark. In the case of closed...