Catalogs >
Canaletas S.A. >
Gel holder accessory

Gel holder accessory
1Pages

Catalog excerpts

Gel Holder Gel holder accessory Support for disinfectant gel on your Canaletas drinking fountain Made from stainless steel Accessory compatible with your Canaletas water coolers and drinking fountains. Maximum hygiene when drinking water. For easy access to disinfectant gel before and after using the drinking water fountains by hand. It can be attached very easily to new or already installed water coolers and drinking fountains, or to the wall if you prefer. Made from stainless steel. Compatible with most gel dispensers on the market. Measurements: Measurements: 1140mm (height) and 914mm (diameter). Installation instructions: To attach it, just remove one of the screws from the water fountain and install the Gel holder at this point (the necessary pieces are supplied). INSTALL DOUBLE SIDED TAPE The Gel holder accessory can replace the current cup holder or be attached to the other side of the water fountain. INSTALL DOUBLE SIDED TAPE HEADQUARTERS AND FACTORY Ronda de Llevant, 10 08820 El Prat de Llobregat Barcelona (Spain) T +34 934 358 546 . F +34 934 350 604 . INTERNET www.canaletas.es www.canaletas.com infox@canaletas.es Canaletas reserves the right to make changes considered opportune to the information contained in the catalogue without prior notice, with the aim to improve its products. *except bottle water coolers and Fonlife drinking fountains

Open the catalog to page 1

Gel holder accessory 1Pages

Catalog excerpts

All Canaletas S.A. catalogs and technical brochures

Gel holder accessory
1Pages