Automatic retractable bollard G6 EVO
2Pages

PRODUCT SHEET Automatic retractable bollard G6 EVO Built-in hydraulic pump Dimensions Power drive (standard version) Built-in hydraulic pump, allowing to reduce the control cabinet size. The bollard is connected using only two electrical cables. This makes installation and commissioning easier. Pump working pressure : 35 bars Voltage in the bollard : 24V-50Hz / 230V-60Hz Maximum power absorbtion : 330w Standard operating temperature range : from -20°C to +80°C Rising time : 5/7 seconds Falling time : 5 seconds Fail safe : in the event of a power cut, the bollard lowers IP67 : waterproof and dustproof Monobloc® design Bollard head, casing and cover made of 11mm average thick cast iron material. These parts are cast as one single piece, without any weld nor wear part. Reliability 4.5 million of operations without any failure neither part replacement (Up to 1,200 operations per day over 10 years). G6 EVO bollards are intended to withstand repeated impacts, rain, frost, sand, dust, solvents agents… 10-year warranty on cast-iron material bollard head, casing and cover, even after a 2.5 tons vehicle collision at 55 km/h*. * See the “Warranty” chapter in our General Terms of Sale ISO EN 124 - E600 Class - Accepted vertical load: 60T per axle. Can be installed in areas that take heavy loads (docks and airports). In compliance with NFP98-310 standard - Regarding characteristics and performances of automatic, semiautomatic and manual retractable bollards. In compliance with the French PMR decree - All dimensions comply with the French decree of 18 September 2012 regarding technical specifications for road and public area accessibility, enabling Persons with Reduced Mobility to have the best possible day-to-day travel. The G6 EVO bollard is equipped with an innovative interchangeable sleeve system for customizing the aesthetics of access points and refurbishing any damaged bollard heads in less than 5 minutes. The bollard head is made of cast-iron material, which provides high impact resistance, covered with a steel or stainless steel sleeve. The new G6 EVO bollard has been designed to make on-site sleeve replacement easy and quick, without need of hoisting device. CAST IRON BOLLARD HEAD PAINTED SLEEVE Treatment : Anti-corrosion paint Material : Steel Design : Cylinder or Chateauneuf Treatment : Zinc-based primer as standard reinforcing corrosion-resistance RAL paint : Matt finish thermosetting polyester powder top coat (RAL7016 standard) STAINLESS STEEL SLEEVE Material : 316L Stainless Steel Design : Cylinder or Chateauneuf Treatment : Polish and satin-finished 316L stainless Steel CUSTOMIZED SLEEVE Material : Steel (Stainless Steel on request) Design : Cylinder Treatment : Zinc-based primer as standard reinforcing corrosion-resistance Customization : Customization with a logo, text, texture, advertising, or image. Finishing : anti-abrasion protection system Intellectual property of URBACO – Copying forbidden – Specifications not contractually binding - Changes may be made without prior notice - Most of the models shown are patented – URBACO S.A – a limited liability company with a capital of 1.5 M€ - Siret 33944567800032 R.C.S. AVIGNON 1999 B 40308 – VAT: FR 06 339 445 678

Automatic retractable bollard G6 EVO Built-in hydraulic pump CAME V URBACO Dimensions (mm) Impact resistance Vehicule weight Speed collision Bollard head with customized ^ sleeve E Class II reflective tape E Illuminated LEDs ring Ml Removable accessories bracket Built-in hydraulic pump assembled to its support Hydraulic cylinder and hydraulic hose Casing Cover Model shown : BHEEVOF75 - Options: customized steel sleeve, white class II reflective tape, blue illuminated LEDs ring, top cover with locking screws and light diffusers. The galvanized steel removable accessories bracket has been...