External Applications Balcony Noise Attenuation Balcony Noise Attenuation using Formboard top pine Panels® Version 1.0 General Information Individual panel segmentation within the following design size: The smaller dimension of the finished parts must not exceed 1300 mm, if coating is required. Our Formboard top pine® panel is a high-density fibreboard bonded with polyurethane. The material is moisture-resistant and it therefore suitable for external applications. The panels are laser-cut to exact dimensions and coated in any desired RAL/NCS S colour. The panels are available in 10 and 18 mm thickness. The Advantages at a Glance Noise absorption of more than 50% Billing of net size only (no wastage!) Precise laser cut allowing for free contour and soft edges according to submitted CAD data Over 100 perforations available from Bruag Option of custom patterns according to your CAD drawing at no additional cost Patterns can run smoothly across multiple panels Wide choice of colours (coating in NCS S Edition2, RAL) Special colours on request Moisture-resistant Colours have excellent lightfastness Ready-to-install product including drill holes and cut-outs Post-processing on site possible (holes and cut-outs) Simple installation

Important Storage/Sorting Note Formboard top pine® panels must never be stored outside in unprotected flat/horizontal position during sorting. Paint damage may occur, if water remains on the panels in a horizontal position! Please store in a protected location and always place the supplied, dry PU-foam foils between the individual panels. Information on Data Submission for Orders When ordering Bruag Formboard top pine® façade panels, please note the following: The following file formats can be submitted DWG / DXF files Cadwork 2D or 3D files Information and Structure Bruag panels must be drawn...

Design Notes Fixing distances Panel Width up to 1000 mm Fixing distances Width Minimum Distance (a) outer edge to centre Maximum Distance (b) centre to centre Maximum Distance (c) centre to centre The diameter of the drill holes is usually 6 mm. The panels are fixed by means of “façade screws with truss head”, diameter 4.8 mm, supplied by Bruag. Alternatively, rivets or other screw types may be used. These must be provided by the contractor and must comply with the applicable requirements. We can paint the chosen fastenings on request. Material: A2 stainless steel Length: 38 / 45 / 60 mm Nominal...

Details and Connections The overall design should be at least 80 mm, ideally 100 mm. The substructure can be made using wood or metal profiles. Formboard top pine® panels are covered first with a fleece or felt and then with a layer of insulation of 30 mm thickness. The cavity behind should be 30 to 50 mm to absorb low-pitched noise. Section Design Section with Shadow Gap Section with Edge Gap For rectangular areas, it is recommended that the structure be set away from the edge on all sides by approx. 100 mm. This makes design and construction more efficient, especially inside buildings. Section:...

Formboard top pine® Panel Fleece or Felt Fixed on the Back Construction Frame Wood/Metal Balcony Floor View from Below with Formboard top pine® 18 mm Perforation 50100

6 Bruag AG Bahnhofstrasse 8 8594 Güttingen Switzerland [email protected] www.bruag.ch