Catalogs >
Bruag Design Factory AG >
1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet
7Pages

Catalog excerpts

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet - 1

External Applications Privacy Screens for Balconies Privacy Screens for Balconies made from CELLON® Panels Version 1.0 General Information Individual panel segmentation within the following design sizes: The maximum width for panels without perforation is 1300 mm. Our CELLON®-panel is a Compact High-Pressure Laminate Panel (HPL) consisting of 70% cellulose sheets and 30% phenolic resin. The weather-resistant material is excellently suited for perforated elements. We use unprocessed HPL panels, which are cut to the exact size by laser. The coating is applied after cutting and it is primarily a visual element. Depending on the perforation and the distance between the fixing points, 8 or 10 mm thick panels are used.

Open the catalog to page 1

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet - 2

Billing of net size only (no wastage) Precise laser cut allowing for free contour and soft edges according to the submitted CAD data, With Over 100 perforation patterns available by Bruag Custom patterns according to your CAD template at no additional cost; Patterns can run smoothly across several boards Large selection of colours (coating according to NCS S Edition2, RAL) Special colours on request Moisture-resistant, frost-proof, termite-proof, High lightfastness of the colours Lightweight (12kg/ m2 for CELLON® 8 mm) Ready-to-install product including drill holes and cut-outs / ^...

Open the catalog to page 2

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet - 3

Panels without Perforation Fixing Distances Panel without Perforation The diameter of the drill holes is usually 8 mm (fastener + min. 2 mm). The screws supplied by Bruag are of the type "self-tapping facade screw with hexagonal head and sealing washer”, diameter 4.8 mm. Alternatively, rivets may be used. These must be provided by the contractor and must comply with the applicable requirements. Painting by Bruag AG is possible. COUNTERSUNK SCREWS MUST NOT BE USED! Material: A2 stainless steel Length: 32 mm Nominal Diameter of Screw: 4.8 mm Head Diameter: 16 mm Drive: SW7

Open the catalog to page 3

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet - 4

Perforated Panels For panel widths of 1500 mm or more, it is essential to provide a vertically continuous centre-support to have a complete row of fixings. Minimum width of support 30 mm. If several panels are connected, 4-6 mm must be allowed for the panel joint. In this case, the support for the screw connection must be at least 70 mm.

Open the catalog to page 4

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet - 5

Details Frame Covered on One or Two Sides Load-bearing frame construction that can be covered on one or two sides with closed or perforated panels. Frame covered on one side View panel without perforation Frame covered on two sides View panel with perforation Perforation 50700 adapted

Open the catalog to page 5

1_4 Exterior Applications - Privacy Screens for Balconies Technical Sheet - 6

Frame with Clamping Strip with or without Intermediate Layer Folded frame construction. Optionally, a solid layer may be placed as intermediate layer in between perforated panels. Frame without intermediate layer Detail View panel without perforation Frame with intermediate layer Detail View panel with perforation Perforation 50403 adapted

Open the catalog to page 6