V7-04 series ball valve actuator is using bi-directional motor. Matching with V7-01 series ball valve body, it is mainly used in central air-conditioning system, heating system, water treatment, and production industry to control the flow of chilled/hot medium • Apply to valves of DN32 to DN50 (can be also apply to valves of DN15-25 as per request) • Fire-retardant ABS engineering plastic, measure up UL94V-0 standard • With manual switch and position indicator • Floating type or modulating type (with internal PCB) • Detachable design, easy to install and maintain • Fluid temperature and ambient temperature are hard to reach inside of actuator. • High reliable and safety requirement level • Actuator manual handle can be disassembled to install on the valve stem for opening or close the valve. • 0(2) ~10V dc or 0(4)~20mA dc control input signal, proportional control. Product code Voltage - Control Signal - Blank: Floating; Valve Type - Valve Size - Breeze Building Technologies V7 Series Floating/Modulating Ball Valve CE II EN607

PCB WIRING I NSTALLAT I ON I NSTRUCT I ON ACTUATOR ROD MANUAL SWITCH ACTUATOR INSTALLATION Rotate the Manual Lever Detach Button Match Locating screw inside Screw down VALVE CONNECTION ACCESSORIES Actuator Stem 1. Calibration mode: After power is on, set JP1 switch “4” to position “ON” as request (refer to the below diagram) , then press SW1 calibration/reset button, power LED is flashing during calibration, and the actuator stem is rotating till to the end (has reached the end position of ball valves). Afterward the stem will rotate back to initial position. Power LED will stop flashing after...