DESCRIPTION V7-03 series ball valve actuator is using bi-directional motor. Matching with V7-01 series valve body, it is mainly used in central air-conditioning system, heating system, water treatment, and production industry to control the flow of chilled/hot medium • Apply to valves size of DN15 to DN25 • Fire retardant engineering plastic, measure up UL94V-0 standard • Integrate with on-off switch at the end of stroke for longer motor life • With manual switch and position indicator • Floating type or Modulating type (with internal PCB) • Detachable design, easy to install and maintain • Good heat insulation design to avoid overheating inside of actuator • Reliable and high safety requirement level • 0(2) ~10V dc or 0(4)~20mA dc control input signal, proportional control. POWER SUPPLY CONTROL SIGNAL FEEDBACK SUPPLY SIGNAL (0)2-10VDC OR SIGNAL 24VAC COM {0]4-20mA DC 0-10VDC Breeze Building Technologies V7 Series Floating/Modulating Ball Valve CE II EN6

MANUAL SWITCH INSTALLATION INSTRUCTION DIMENSION INSTALLATION INSTRUCTION Unscrew Match Locating * Pin to the recess Screw down Switch limiter adjuster (Adjustable accuracy 10*)^ Match the positions of Square Shaft and Actuator Stem (7*4) Oblong shaft (9*9) Square alxe shaft Oblong shaft shall be with square connector. DN15, DN20 and DN25 series ball valve PCB SETTING 1. Calibration mode: After power is on, set JP1 switch “4” to position “ON” as request (refer to the below diagram) , then press SW1 calibration/reset button, power LED is flashing during calibration, and the actuator stem is rotating...