Roll-In Final prooferPerformances Use • Fermentation chamber for racks 400/460x800, 600x800, 700x900, 750 x 900 depending on model up to 800 x 1000 mm • Cells are defined by their internal width (800, 1000, 1200, etc...) they can be installed side by side • Door handle on the left unless otherwise specified The BFE proofer is used to reach a set temperature (30°C-38°C) very rapidly. It is used for fast proofing of baking and pastry products. Operating principle A technical unit (ventilation, heat production and humidity production) placed inside the enclosure warms the air to a set temperature defined by the user (30°C-38°C). An electromechanical hygrostat regulates the humidity rate from 30% to 90%. Ventilators maintain an even temperature and humidity at all times throughout the proofer. Construction The advantages • Custom made product • Easy to assemble panels by means of excentric hooks • Electromechanical regulation • Electromechanical hygrostat • Maximum proofing temperature : 30°C -38°C • 60 mm thick isothermal Panels. • Made of modular panels assembled by eccentric hooks • The panels are injected with polyurethane foam, of a density of 40 kg / m3 • Sheet metal coating, inside aluminium of 8/10 thickness pre-lacquered, painted and coated with a protective polyethylene covering • Plain doors (same material as panels with single or/and double door) • The wall panels are fitted into a base frame made of PVC of 30 mm height fixed to the floor • Inside lighting • Connecting power : 400 V (3 PH + N + Gr) 50 Hz Options • Electronic pin type humidity sensor (only with electronic regulation Opticom) • Insulated floor with stainless steel ramp • Stainless steel interior and isothermal hot electro-plated zinc exterior panels, pre-lacque-red, painted and coated with a protective polyethylene covering • Stainless steel (5/10 thick) interior and exterior • • • Important notes : BFE's are supplied without rack.

2 Water supply in copper pipe 0 12 - 2,2 m from the floor, only 1 water supply is necessary for a maximum of cells 3 PVC water drain pipe 0 32 from 0 to 0,2 m from the floor 5 Technical unit 6 Guides 7 Racks Technical module 800 or 1000 made of stainless steel The functions : • Ventilation • Heating • Humidifying Are all collected in a technical module Control panel • Placed above the door, it contains the necessary controls for the rational use and the functioning of the chamber • An electrical power supply is necessary per compartment