SPANRIB® IYSACHT DESIGN AND INSTALLATION GUIDE ^—

LYSAGHT SPANRIB® The SPANRIB® cladding system provides the benefits of long spanning, pierced-fix cladding, with excellent rainwater carrying capacity. All overlapping ribs have specially formed capillary grooves to prevent water entering at the side laps. It has been designed for commercial and industrial applications where long span and fast installation are major requirements. Each sheet requires only 3 fasteners per support, so with 820mm cover, installation is very fast and less costly. Available in Queensland. TOLERANCES Length: + 0 mm, – 15 mm, Cover width: + 4 mm, – 4 mm MAXIMUM SUPPORT...

SPANRIB® LIMIT STATE WIND PRESSURE CAPACITIES (KPA) 0.42 BMT Span Type Limit State SPANRIB® LIMIT STATE WIND PRESSURE CAPACITIES (KPA) 0.48 BMT Span Type Limit State Supports must be not less than 1mm BMT. or if end lap End spans t in sheeting join expansion Roong & Walling Proles Roong & Walling Proles or if end lap End spans t in sheeting join expansion Spacing denitions ES = End Span IS = Internal Span O = Overhang SS = Single Span MAXIMUM ROOF LENGTHS FOR DRAINAGE MEASURED FROM RIDGE TO GUTTER (M) SPAN TYPES Penetrations will alter the flow of water on a roof. For assistance in design of...

INSTALLATION Below are typical guidance on installation. For more detailed installation guidance refer to the LYSAGHT® Roofing & Walling Installation Manual. Crest: 3 fasteners per sheet per support at single, end and internal supports FIXING SHEETS TO SUPPORTS SPANRIB® is pierce-fixed to steel supports. This means that fastener screws pass through the sheeting. To achieve watertightness of SPANRIB®, always place roof screws through the crest. Always drive the screws perpendicular to the sheeting. Don’t place fasteners less than 25mm from the ends of sheets. END LAPPING End-laps are not usually...

FASTENERS WITHOUT INSULATION Fix to Steel Single & lapped steel thickness ≥0.55 up to 1.0mm BMT Crest Fixed Fix to Steel Single steel thickness ≥1.0mm BMT up to 3.0mm BMT Fix to Steel Total lapped thickness ≥1.00 BMT up to 1.9mm BMT Notes: 1. For other steel thicknesses not specified please seek advice from screw manufacturer. 2. Values given are: gauge/threads per inch/lengths (mm). HH = Hex. Head, WH = Wafer Head, HG = Hi-Grip 3. Care is required during installation to prevent stripping of thin material. (Single ply.) 4. Screw specification as above or equivalent fastener. 5. All screws with...

PRODUCT DESCRIPTIONS • All descriptions, specifications, illustrations, drawings, data, dimensions and weights contained in this catalogue, all technical literature and websites containing information from Lysaght are approximations only. They are intended by Lysaght to be a general description for information and identification purposes and do not create a sale by description. Lysaght reserves the right at any time to: (a) supply Goods with such minor modifications from its drawings and specifications as it sees fit; and (b) alter specifications shown in its promotional literature to reflect...