Innovative end/expansion joint solution for KLIP-LOK 700 HI-STRENGTH® 3 Fast and easy to install – no pre-drilling required 3 Suitable for cyclonic locations 3 Minimal change to installation practices 3 afe and effective S weather resistant seal. 3 No special purlin detailing required 1

LOK-KLIP™ and KLIP-LOK 700HS The new LYSAGHT LOK-KLIP™ system provides installers with a quick and easy end joint/expansion joint solution between overlapping sheets of LYSAGHT KLIP-LOK 700 HI-STRENGTH®. The LOK-KLIP™ system comprises a fully engineered ZINCALUME® steel bracket and a custom shaped weather resistant polyethylene foam weather strip. The LOK-KLIP™ bracket replicates the role of a standard concealed fix bracket and is secured to the ribs of the bottom sheet using standard roofing fasteners. Benefits of LOK-KLIP 3 ow profile system maintains clean, long run roof lines of L KLIP-LOK®....

LOK-KLIP joint layout and fixing This will allow normal concealed fastening at the support and thus allowing thermal movement to occur at the LOKKLIP. To install the LOK-KLIP bracket, locate each LOK-KLIP bracket as per Figure 5, then hand press to snap fit each LOK-KLIP bracket to the KL-700HS rib. (Figure 4a, 4b) For non-cyclonic areas, using a low torque setting on the drill to ensure the cladding is not stripped, secure through the top hole of the LOK-KLIP and also through the crest of the lower sheet. (Figure 4a) For cyclonic areas, use two fasteners by fixing through the sides of the LOK-KLIP...

Turn up and turn down of KL-700HS at LOK-KLIP joint Roof design considerations The roofing sheets are not to exceed the maximum recommended END span either side of the LOK-KLIP joint. To ensure drainage, refer to table below. Table 2 Drainage Purlin Spacing Minimum Roof Slope 1750mm 1º 1250mm 1.5º 850mm 2º For advice on roof drainage, refer to the LYSAGHT Roofing & Walling Installation Manual. It may be necessary to employ packers to provide a more gradual change in the slope of the roof. When specifying or ordering, please refer to the layout schematic detailed below. Turning-up Turn-ups are...

Upper sheet Then continue laying upper sheets to end of roof First continue laying lower sheets to end of roof (or gap) Packers may be required here prior to fixing off KL-700HS clip assemblies Figure 9: Laying sequence for KL-700HS end joint Step 1: The installation of KL-700HS should generally be in accordance to the instructions given in the LYSAGHT Roofing and Walling Installation Manual. Install the lower sheets of the KL-700HS prior to installing upper sheets as per the above sequence. The number of sheets laid will depend upon the site conditions and installer programme. Packers (10mm...

Product Descriptions Disclaimer, warranties and limitation of liability All descriptions, specifications, illustrations, drawings, data, dimensions and weights contained this catalogue, all technical literature and websites containing information from BlueScope Lysaght are approximations only. They are intended by BlueScope Lysaght to be a general description for information and identification purposes and do not create a sale by description. BlueScope Lysaght reserves the right at any time to: This publication is intended to be an aid for all trades and professionals involved with specifying...