design and installation guide

Lysaght Custom Orb Accent® 35 Commercial corrugated steel cladding With corrugations 60% deeper and 50% wider than traditional corrugated profiles LYSAGHT Custom Orb Accent® 35 is ideally suited to the large cladding areas in modern industrial, commercial, residential and recreational buildings. The combination of deeper, wider ribs also delivers real performance benefits over the life of a building. Stronger than traditional corrugated not only means it’s tougher, thereby reducing the potential for damage during installation and maintenance, but also means it can span greater distances leading...

CUSATOM ORB ACCENT 35 lysaght custom pressure capacities (kPa) 0.48BMT Limit State wind orb ACCENT 35: Limit State wind pressure capacities (kPa) 0.48mm BMT Span Serviceability Strength • Table data are based on supports of minimum 1mm BMT. Roofing & Walling profiles Limit states wind pressures custom orb accent 35 offers the full benefits of the latest methods for modelling wind pressures. The Wind Pressure capacity table is determined by full scale tests conducted at Lysaght’s NATA-registered testing laboratory, using the direct pressure-testing rig. Testing was conducted in accordance with...

Installation Crest xing for roof or walls Crest: 3 fasteners per sheet for internal supports Crest: 6 fasteners per sheet for end supports (including single spans) Valley xing for walls only side lap Valley: 3 fasteners per sheet for internal and end supports side lap Don't x here At end support, cut because underlapped out underlap sheet would leak. locally. Valley: 6 fasteners per sheet for end supports (including single spans) Fastening sheets to supports custom orb accent 35 is pierce-fixed to timber or steel supports. This means that fastener screws pass through the sheeting. If you want...

Turning-up custom orb ACCENT 35 custom orb ACCENT 35 Flashings and Cappings This section describes how you can treat the ends of sheets to maximise waterproofing, or to stop vermin entering. Standard flashings and cappings are available. (See below.) At the high end of roofing, wind can drive water uphill, under the flashing or capping, into a building. To minimise this problem, you turn up the valleys (or pans) at the high Standard Flashings Description end of roofing. (The process is called turning-up (or stopending). Standard Flashings Description All roofing on low slopes (≤25º) should be...

Product Descriptions All descriptions, specifications, illustrations, drawings, data, dimensions and weights contained in this catalogue, all technical literature and websites containing information from Lysaght are approximations only. They are intended by Lysaght to be a general description for information and identification purposes and do not create a sale by description. Lysaght reserves the right at any time to: (a) supply Goods with such minor modifications from its drawings and specifications as it sees fit; and (b) alter specifications shown in its promotional literature to reflect changes...