Catalogs >
BISOL >
BISOL EasyMount ALU Triangular

BISOL EasyMount ALU Triangular
2Pages

Catalog excerpts

BISOL EasyMount ALU Triangular Versatile and resistant solution for flat roofs BISOL EasyMount ALU Triangular mounting system is suitable for PV installations on roofs with larger spans of the roof bearing structure, or roofs requiring higher wind and snow load resistance. The structure is available in several different incline angles and can be simply laid out without drilling into the roof. For pitched roofs, or if extra stability required, the ALU Triangular structure is mounted into the roof structure using hanger bolts. The pre-assembled bolt connections on the A-frame reduce the on-site installation time. Technical Specifications Solution with EasyMount ALU Rail 80 Solution with EasyMount Profile 80 and Hanger bolts Flat roofs covered with bitumen, gravel or synthetic membrane Flat roofs covered with bitumen, gravel or synthetic membrane / Pitched roofs with trapezoidal or corrugated metal sheet Roof incline Laying without roof penetration Fixing with hanger bolts into the roof structure Method of installation Module incline 12.5°, 20° and 30° (other angles available upon request) Module orientation Module frame tolerances Material Landscape (portrait upon request) Suitable for most framed module dimensions / Frame thickness: 35, 40 or 45 mm (1.38”, 1.57” or 1.77”) applicable to different clamp types Aluminum EN-AW 6060 T5 (L-profile, ALU Rail 80, Profiles 50 and 80) / Stainless steel A2-70 (fastening elements) System weight without ballast Snow load per system 0 – 2.40 kN/m2 (with BISOL PV modules) Wind load (velocity) Additional stabilization 0 – 110 km/h (68 mph) / Wind zones 1, 2, 3 Ballast (concrete slabs) / Windshields Various incline angles With or without roof penetration Lightweight layout option Resistant to heavy loads Suitable for high wind zones

Open the catalog to page 1

System Components U-connectors allow for the extension of Profiles 50. Profiles 50 are mounted on L-profiles. Pre-assembled end and middle clamps are mounted on Profiles 50. Metal windshield can be attached on the reverse side of the triangular structure. Additional ballast (concrete slabs) can be placed into specially prepared double-sided console applied over the ALU Rail 80 profile. The A-frame is mounted on ALU Rail 80 using two connecting elements. Components required for mounting using hanger bolts Connector 80 allows the extension of Profile 80 by inserting into connecting profiles...

Open the catalog to page 2