BAUTECH TL SYSTEM NOVEMBER 2012 1/2 BAUTECH TL SYSTEM SYSTEM DESCRIPTION A thin‐layer flooring system for industrial and public facilities subject to pressure corresponding to light and medium conditions of wheel transport and periodical pedestrian traffic. Resistant to impacts, pressure and shocks typically occurring during the loading of light and medium cargo. AREAS OF APPLICATION A flooring system to be used on stabilized concrete foundations and cement screeds, meeting standard smoothness and capacity‐carrying parameters, e.g. :  technical rooms  utility rooms  storage facilities  parking areas USABILITY At the temperature of 20˚C and relative air humidity of 60‐70%: ‐ pedestrian traffic – after 24 hours ‐ mechanical loads – after 72 hours ‐ complete resistance – after 7 days. CAUTION System is not resistant to metal and polyamide wheel loads. LEGAL NOTES All information contained herein is based on the current state of knowledge resulting from performed trials and laboratory tests. As it has no control over the actual manner and conditions of application of materials included in the system, Bautech Sp. z o.o. informs that the data contained herein as well as any oral advice not confirmed in writing may not constitute a basis for unconditional legal liability of the producer. All previous technical sheets become void with the publication of this one. MISCELLANEOUS INFORMATION Other information regarding the conditions of application, use, cleaning and maintenance of polymer floors by Bautech Floor System is included in Technical Instructions and Technical Sheets of individual products. Concrete foundation must be stable and of proper carrying capacity for the target static and dynamic loads – concrete of class no less than C20/25 of minimal stripping strength 1.5 N/mm2. The acceptable humidity of the foundation must not exceed 4% in terms of weight. The foundation must have a hermetic horizontal insulation protecting it from moisture sucked up through capillary tubes. Foundations which are to be protected with epoxy layers must be clean and absorbent. Cement wash, dirt of all kinds and old protection layers should be removed mechanically by grinding, shot blasting or milling.

BAUTECH PARKING SYSTEM NOVEMBER 2012 2/2 DETAILED DESCRIPTION OF TECHNOLOGY Grounding layer Material: BAUPOX 100 STR. Spread properly mixed material on concrete foundation in one or two layers, using a rubber squeegee and then a roller, until full saturation is achieved. Consumption: 0,25 – 0,50 kg/m2. 1st main layer Material: BAUPOX 200 Spread the resin evenly on the foundation using a roller for resins. After polymerization, delicately regrind the surface with a grinder with abrasive paper and then remove dust from the whole of it. Consumption of resin: 0,25 – 0,30 kg/m2. ...