FD-RE0x OrangeLink Bidirectional Legic reader/writer Functional characteristics ® The FD-RE-01 and FD-RE02 are card reader modules which can read and write data to LEGIC contactless cards with the following characteristics: ® ♦ Able to energize LEGIC cards at 13.56 MHz at a distance of about 2 cm from the antenna (antenna is located bottom center of the reader) ® ♦ Able to read and write data on LEGIC cards ® ♦ Communication with cards that carry data encrypted according to the LEGIC protocol ♦ Read data registration (entry/exit) by means of photo sensors on the left and right of the reader ♦ Visual indications through 2 multicolored LEDs (red/green/yellow/blue) in the little arrow symbols on either side of the reader ♦ Indication of a field present by sequential illumination of the blue wave symbols on either side of the reader ♦ Audible signal through an internal buzzer ♦ Connection to the FD-BUS using SPP (Serial Proprietary Protocol) at a speed of 115.2 Kbaud (default) or 19.2 Kbaud ♦ Address selection for the reader by means of a rotary switch on the back of the device ♦ Double connector (internally in parallel) for easy reconnection to the FD-BUS. Only FD-RE02 ♦ Display of alphanumeric and semi-graphical information on an LCD display, on 2 rows of 16 characters with BLUE backlight ♦ Automatic disabling of the display backlight to save energy when operated from the battery Protection The equipment is protected against the following events: ♦ polarity reversal on the cables (RJ45) connecting to the FD-BUS ♦ voltage surge in the power supply and data lines Modes of Operation The FD-RE02 module can read LEGIC® contactless cards in registered and non-registered mode. ♦ In registered mode (entry/exit for attendance registration), the LEGIC® card is read by presenting the card at the luminous wave symbols on the left or right of the reader. ♦ In non-registered mode (access control), the LEGIC® card is read by presenting the card at the center of the reader. Visual indicators The FD-RC0x module can give the user indications by means of: ♦ ♦ ♦ ♦ alphanumeric LCD display (only FD-RC02) 2 multicolored LEDs located in the arrow symbols blue LEDs in the wave symbols buzzer FD-RE0x-DS-02-en.doc The most common indications are as follows: ♦ When switched on, the module displays the address previously set with the rotary switch. ♦ If there is no polling from the Field Manager, the module displays the message “No communication” and both arrows flash yellow. ♦ When the module receives the configuration from the Field Controller, the blue wave symbols on either side of the reader begin flashing. ♦ On access grant, the arrow symbol corresponding to the direction of passage is lit green. and an audible signal is given. Pg. 1/2

Power supply Through the FD-BUS connectors 300 mA during card reading (at 14VDC) 80 mA with backlight off (at 14VDC) (only FD-RE02) FD-BUS (2 RJ45s in parallel) with RS485 and power supply FD-BUS communication Differential RS485 serial interface Baud rate (nominal) 11,5000 baud Rice transmitter Read/write of LEGIC® contactless cards at 13.56MHz Excitation of transponder by pulse wave with anti collision capability Typical reading distance 20mm_ Bidirectional reading Direction management by 2 photo sensors Operating temperature Protection class Address selector 0 to 15 by rotary switch selector...