City Alphabet – urban furniture
2Pages

TECHNICAL DATA: GENERAL INFORMATION: 1. Dimensions: Metric: ( Inch ) Polyester-glass laminates (PWS) based on eco-friendly polyester resin are used for the production of the CITY ALPHABET letters. The highest quality materials ensure the strength, durability and resistance to soiling, mechanical damage and weather conditions. Assembly sheets (optional) made of stainless steel, covered with powder paint. Empty letter: approximately 73 kg ( 162 lb ) Filled letter: approx. 123 kg ( 273 lb ) Semi-finished products used for the production of the letters can be used from -40°C to 80°C ( -40°F to 176°F ). The components cannot be permanently immersed in water. Wide range of colours according to the RAL palette. At the individual request of the customer, special colour variants are also available. The letter can be installed (additional option) to the previously prepared foundations with mechanical anchors. Safety regulations must be observed during installation. Due to large dimensions, it is recommended to perform the assembly with a crane or a forklift. Installation details on the back of the document. Cleaning and maintenance operations depend of the place of installation. It is recommended to perform thorough cleaning and general inspection for possible damage at least once a year. It is recommended to apply a coating facilitating cleaning and preventing permanent soiling in accordance with the "Cleaning and maintenance instructions for products made of glass-polyester (PWS) laminate)". 1. Why is it worth using the GRP material? Use of glass-polyester laminate (PWS) allows: ✓ obtaining complex shapes not available through production processes. ✓ high stiffness and strength of the components despite low weight. ✓ implementation of unit orders with various colours. ✓ using eco-friendly raw materials for environmental protection; no hazardous volatile compounds are emitted from the surface of the products. ✓ repairing possible damage. ✓ manufacturing from materials with the Hygienic Certification 2. Maintenance Products made of PWS laminate can be washed and maintained. The agents used should not damage the surface of the laminate; they should act only on the given type of soiling in order to remove it. The list of cleaning agents is available in "Cleaning and maintenance instructions for products made of glass-polyester (PWS) laminate". For other cleaning agents it is required to perform a test on an invisible surface. It is forbidden to use agents and substances which may scratch the surface or cause other permanent damage. 3. UV protection Using the highest quality gel coats, resins and coating materials from the leading manufacturers ensures resistance to UV radiation and weather conditions. 4. Unique properties The highest quality materials and many years of experience of the leading European manufacturer of PWS laminates make it possible to obtain the products with not only high quality but also with a unique design refined in every detail. Each project is considered individually by our employees to meet all customer requirements. Therefore you can be sure that our products are unique and unrepeatable and will distinguish your company. 5. Resistance to vandalism The very high strength of PWS laminates ensures resistance to impacts and scratches. At the request of the customer, we can also use flame-retardant materials that improve operational safety and protect against vandalism. 6. Certificates held by the company: ✓ ISO 9001 ✓ ISO 14001 ✓ IRIS ✓ Hygienic Certificate

2) Complete set for the "B" letter should consist of the following components: 1) Unpack all components and check whether they were not damaged during transport 3) Tighten assembly sheets located on the bottom of the letter with M8x50 DIN 7991 bolts 4) Place the letter on prepared foundations. Mark the drilling points for holes of the anchor rods in the assembly sheets 5) Put the LETTER aside during drilling in the foundations to avoid damaging its surface. It is forbidden to drill through the openings in the assembly sheets. 6) Drill 6 openings for assembly anchors acc. to the previously...