3.3 Anti-Microbial Preservation Tactite is a water-based, semi-transluscent decorative wall coating which features a soft touchђ feel to create a warm inviting interior with a suede or textured finish. Test Method Result Anti-Fungal Activity No visible growth Anti-Algal Activity No visible growth Anti-Bacterial - JIS Z 2801 > E Coli No bacteria survived MRSA No bacteria survived Salmonella No bacteria survived A cost effective alternative to decorative paint effects, wall paper and vinyl wall coverings. Օ Provides a seamless, durable, cleanable, hardwearing and low maintenance wall finish. > Available in a range of 36 colours with a Ցsoft touch suede effect. For interior use only. ҕ Formulated to prevent mould, mildew and bacterial growth. Low VOCs and low odour. > Օ Coverage rate: 16 - 20 m/litre/coat depending on substrate. One 5 litre unit will cover approximately 40mҲ (400ft) in 2 coats. 5.1 New Surfaces ҕ Ensure all surfaces are sound, clean and suitably dry. Drying times: 4 Ֆ 8 hours. Dense or highly polished surfaces should be coated with an appropriate primer to promote effective adhesion. > 3.1 Scrub Resistance Օ Porous surfaces should be primed with a mist coat of BaseColor Satin thinned with up to 20% clean water. The Tactite system (BaseColor Satin, Tactite) was tested for wet scrub resistance according to ASTM D2486 and ISO 2812. Leave to dry. 5.2 Previously decorated surfaces Test Method Result Comment ASTM D2486 1150 cycles Օ Ensure all surfaces are sound, clean and suitably dry. ISO 2812 Class 2 Classed as washable Remove any loose or flaking material back to a sound firm edge. Testing was carried out by accredited testing laboratories. Օ Treat any organic growth with a fungicidal wash. 3.2 VOC Testing Fill any holes, cracks or surface defects. Օ Surfaces that exhibit high sheen levels should be wet abraded to provide a key. A sample of Tactite was tested for VOC following procedures outlined in ASTM D3960 Standard Practise for Determining Volatile Organic Compound (VOC) Content of Paints and Related CoatingsӔ and ISO 11890-2 Paints and varnishes. Determination of volatile organic compound (VOC) content.Ӕ Wash down sound paintwork with warm water and an appropriate cleaning agent to remove any contaminants. Օ Rinse surfaces with clean water to remove any residues. Spot prime any bare or filled areas with a mist coat of BaseColor Satin or an appropriate primer as necessary. Test Method Result Comments ASTM D3960 48 g/lt US EPA requirement (<250g/lt) Օ Leave to dry. ISO 11890-2 15g/lt EU requirement for Cat A/l (300g/lt) Technical Data Sheet TDS303 Tactite Page 1 of 2 >

To apply Tactite you will require the following tools and materials: Store in good dry conditions between 5 25ְC. Protect from frost. Protect from sunlight and sources of direct heat. Keep container sealed when not in use. ArmourColor BaseColor Satin Օ ArmourColor Tactite Shelf life of Tactite in an unopened container under correct storage condition is 12 months from date of manufacture. 9Ք paint roller with a short pile roller head Roller tray Օ 4 Tactite patterning brush ԕ 2 Masking tape > 10.1 Cleaning Surface Dirt and Grime > Mix a small quantity of liquid detergent or soap into a bucket...