3.2 VOC Testing Perlata is a water-based, decorative wall coating specially formulated with pearlescent pigments to create an elegant finish with a subtle surface shimmer. Perlata is available in a wide range of colours which are suitable for both modern and classical interiors. A sample of Perlata PLS was tested for VOC following procedures outlined in ASTM D3960 Standard Practise for Determining Volatile Organic Compound (VOC) Content of Paints and Related CoatingsӔ and ISO 11890-2 Paints and varnishes. Determination of volatile organic compound (VOC) content.Ӕ > Test Method Result Comments ASTM D3960 209 g/lt US EPA requirement (<250g/lt) Quick and easy to apply. Օ Economically priced to appeal to a variety of design requirements. ISO 11890-2 82g/lt EU requirement for Cat A/l (300g/lt) Supplied ready for use. Օ Can be tinted to a wide range of colours using a silver or gold base. Perlata range also includes a preparative base coat, BaseColor Matt and a protective top coat, Clearseal Gloss. 3.3 Anti-Microbial Preservation Test Method Result Օ Formulated to prevent mould, mildew and bacterial growth. Anti-Fungal Activity No visible growth Anti-Algal Activity No visible growth Low VOCs and low odour. Anti-Bacterial - JIS Z 2801 Օ Coverage rate: approximately 10-14 m/lt/coat E Coli No bacteria survived ҕ One 5 lt unit will cover approximately 30 m (300 ftҲ) in 2 coats. MRSA No bacteria survived Salmonella No bacteria survived Drying time 3-4 hours. 3.4 Fire Test Results > Test Method Result Comments ASTM E84 Class 1 Perlata system tested 3.1 Scrub Resistance (BaseColor - 1 coat, Perlata - 2 coats, Clearseal Gloss - 1 coat) The Perlata system (BaseColor, Perlata PLS, Clearseal Gloss) was tested for wet scrub resistance according to ASTM D2486 ՓStandard Test Methods for Scrub Resistance of Wall Paints. BS476 Part 6&7 Class 0 Perlata system tested (BaseColor 1 coat, Perlata 2 coats) Test Method Result ASTM D2486 1000 cycles > Testing was carried out by an accredited testing laboratory. For interior use only. Technical Data Sheet TDS301 Perlata PLS/PLG Page 1 of 3 >

5.1 New Surfaces Surfaces to receive Perlata must be prepared as ready for painting. Ensure all surfaces are sound, clean and suitably dry. These instructions are offered as a guide only. Always try small areas first before attempting large walls. A demonstration DVD and training courses, which would offer greater insight, are available. Օ Dense or highly polished surfaces should be coated with an appropriate primer to promote effective adhesion. Porous surfaces should be primed with a mist coat of BaseColor Matt thinned with up to 20% clean water. Օ Stir product thoroughly before use. Apply...

Perlata is a non-toxic water-based product. Ensure good ventilation during application and drying. Avoid contact with skin and eyes. Keep out of reach of children. Please refer to the Safety Data Sheet for further information. > Store in good dry conditions between 5 25ְC. Protect from frost. Protect from sunlight and sources of direct heat. Keep container sealed when not in use. Shelf life of Perlata in an unopened container under correct storage condition is 12 months from date of manufacture. > 10.1 Cleaning Surface Dirt and Grime Mix a small quantity of liquid detergent or soap into a bucket...