Uniline Series UL210D Line Array downfill and mid throw elements Three acoustic ways 2 x 10" neodymium (w/2" voice coil) 6,5"+ 1" neodymium HF divers, coaxially mounted Features Very wide horizontal coverage Progressive vertical index directivity Limited weight Full acoustical and mechanical compatibility with UL210 Applications Short and mid throw coverage UL210 down fill reinforcement Wide venues and listening areas Specifications 80 Hz - 19 kHz (wide band mode) LO/MID: 800 W AES 99 dB SPL @ 1W at 1m MID/HI: 300 W AES 108 dB SPL @ 1W at 1m Max SPL@ 1m 137 dB 10.4" x 27.6" x 23" (264 x 700 x 584 mm) Bi-amplified operation Digital processor mandatory The UL210D Uniline “line array” incorporates 3-way bi-amplified system design. Twin 10" loudspeakers loaded in compression serve Lo/Mid bandwidth between 80 Hz and 450 Hz. Mid/Hi coherency comes from coaxially aligned 6,5" and 1" The mid-range 6,5" speaker displays ultra-low distortion and extends from 450 Hz to 4 Khz. The 1" HF driver operates smoothly from 4 Khz to 19 KHz. The two Neodymium drivers are mounted coaxially and loaded with an ISOTOP10™ waveguide. This assembly consists in an annular horn and iso-phase technology to achieve acoustic impedance adaptation and performance that is comparable to traditional compression drivers, but with greatly increased bandwidth and power handling. Directivity control, compression and transducer phase alignment are all established through the UL210’s advanced acoustic horn. The mechanical rigging system is totally integrated and fully identical to the UL210 speaker. It allows use of Uniline both in flown and stacked installation. Six recessed handles allow UL210 enclosures to be easily handled during transport, rigging and installation. Use of an APG digital processor is required. The processing and amplification system of UL210 and UL210D are independent. The UL210D speaker has been first developed as a complement to a UL210 based main line array system. The UL210D are designed to be used as a short and medium throw system of its own, or as downfill speakers of a UL210 based system at the bottom of the cluster, or as front fill if put in front for the stage for large stages. Thanks to its 105° acoustic horizontal opening with constant directivity, the UL210D enables to cover the near field area without any compromise, even on very large stages. The UL210D is equipped with the same type of loudspeakers, in order to provide with a perfectly equivalent sound restitution, fully compatible with UL210. The ISOTOP10™ is identical to the UL210 in order to guarantee a continued acoustic line. The rigging and transport system of UL210D is identical to UL210. The UL210D is significantly lighter than UL210. For shorter throw and wider acoustic coverage applications, the UL210D speakers can be used as main system, in large band for vocal applications and combined with UL115B and/or TB subs for musical applications.

210DTechnical specifications Features Frequency response, 2 way (1) Frequency response, 3 way (1) Frequency response, 4 way (1) Efficiency 1W @ 1m Max level @ 1m Peak level dB SPL @ 1m Directivity, angles to -6 dB (2) Nominal Impedance Enclosure Components Transducers Coil diameters of Type of load Bass Reflex IsotopTM driver and horn Power Requirements Recommended amplifiers (3) Peak AES (4) Construction and characteristics Multiple Enclosures (1) In standalone mode, the UL210D low frequency cut-off is approximately 65 Hz but it depends on the number speaker of clusters. In extended mode and...