MS-R1 Recycled rubber MS-R1 - a Wall Bearing material - is part of the Amorim Cork Composites range and it represents an excellent solution for acoustical and vibration issues. MS-R1 is manufactured from recycled granulated rubber and it has been developed to effectively interrupt the transmission of footstep noise vertically through the masonry. If wall bearings are used consistently throughout a building, and other sound transmission vectors are eliminated, this can significantly improve the quality of living conditions. The product is suitable for acoustic insulation in loadbearing and non-load-bearing walls. LOAD RANGE Workload (MPa) A D VA N TA G E S ▸▸ High resistance to compression ▸▸ Low dynamic stiffness ▸▸ Resistance to contact with liquids ▸▸ Recyclable BENEFITS ▸▸ High load bearing capacity ▸▸ Low thermal conductibility ▸▸ Lasting elasticy ▸▸ Easy to cut ▸▸ Stable creep behavior ▸▸ Block flanking ➀ DIN 53513 (adapted) - tangential modulus ➁ DIN 53513 (adapted) - depending on load and frequency T E C H N I C A L F E AT U R E S Compression Set (%) ➀ Tensile Strength (MPa) ➁ Elongation at break (%) ➁ Density (kg/m³) ➂ Shore Hardness (Shore A) ➃ Natural Frequency (Hz) for 10mm thickness ➀ DIN 53572 - Measured 30min after decompression with 50% deformation / 23ºC after 72h ➁ DIN 53571 ➂ ASTM D297 ➃ A

Note: Creep over 20 years less than 10% DYNAMIC STIFFNESS [N/MM³] Dynamic Stiffness [N/mm³] ▸▸ 10mx5cmx10mm or 5mm ▸▸ 10mx10cmx10mm or 5mm ▸▸ 10mx15cmx10mm or 5mm ▸▸ 10mx20cmx10mm or 5mm * Other dimensions available After the surface layer has been allowed to dry, lay the wall bearing. Make sure that it projects by approx. 15mm on the side on which the wall is to be plastered; PHYSICAL AND MECHANICAL PROPERTIES Sections of wall bearing are butt-jointed together, and the joint secured with adhesive tape for concrete. Before the MS-R1 wall bearing is installed, check the floor for surface irregularities....