*myarchiexpo

AD-210 Models

Product catalog summary

Overview: The document provides detailed technical specifications for the AD-210 models, including both Non-Tilt and 2-Way Tilt versions, available in gas and steam configurations.

Specifications:

Maximum Capacity: 200 lb (90.72 kg) for both models.
Tumbler Dimensions: Diameter of 62-1/2" (158.75 cm) and depth of 42" (106.7 cm), with a volume of 74.5 cu ft (2,109.60 L).
Drive Motor: 3 hp (2.24 kW).
Door Opening: 36-3/4" width x 43" height (93.3 cm x 109.2 cm).
Compressed Air: Non-Tilt requires 3.25 cfh (0.25 cmh) with a 1/8" F.N.P.T. connection, while 2-Way Tilt requires 9 cfh (0.25 cmh) with a 3/8" F.N.P.T. connection.
Exhaust and Water Connections: 20" (50.8 cm) exhaust connection and 3/4" F.N.P.T. water connection.

Gas Model Specifications:

Voltage: Available from 208-575v, 3-phase, 3 or 4 wire, 50/60 Hz.
Blower/Fan Motor: 7-1/2 hp (5.6 kW) for rear exhaust and 15 hp (11.2 kW) for side exhaust.
Heat Input: 650,000 Btu/hr (163,810 kcal/hr).
Airflow: 5,300 cfm (150.08 cmm) at 50/60 Hz.

Steam Model Specifications:

Voltage: Available from 208-575v, 3-phase, 3 or 4 wire, 50/60 Hz.
Blower/Fan Motor: 15 hp (11.2 kW).
Steam Consumption: 890 lb/hr (404.5 kg/hr) with an operating pressure of 125 psi max (8.6 bar).
Airflow: 6,500 cfm (184.06 cmm) at 60 Hz and 5,417 cfm (153.38 cmm) at 50 Hz.

Electrical Service Specifications:

Gas Rear Exhaust: Total current varies by voltage, e.g., 37.6 amps at 208V, 3-phase, 60 Hz.
Gas Side Exhaust and Steam: Total current varies by voltage, e.g., 54.7 amps at 208V, 3-phase, 60 Hz.

Important Notes:

Ensure correct voltage specification when ordering, as 208 VAC and 230/240 VAC are not the same.
Circuit breakers must be thermal/magnetic (industrial) motor curve type and 3-pole for 3-phase dryers.

Catalog excerpts

Gas Side Exhaust and Steam - Electrical Service Specifications (Per Dryer) AD-210 NON-TILT STEAM MODEL QY160049 1/1788 Currant Road, Fall River, MA 02720-4781 • 508.678.9000 • www.adclaundry.com

Open the catalog to page 1

»*20* DIA EXHAUST DUCT CONNECTION

Open the catalog to page 2

210 2 D00R/2-WAY TILT# OAS MODEL * BOTH GAS AND STEAM UNITS MUST BE SUPPLED WITH CLEAN. DRY. REGULATED AIR AT 80 PSI ± 10 PSI (552 BAR ± .69 BAR). »* DUCTWORK SIZE VARIES WITH INSTALLATION CONDITIONS. EXHAUST STATIC PRESSURE SHOULD NOT EXCEED 03* WATER COLUMN (0.74 mb). *** SIZE OF PIPING TO DRYER VARIES WITH INSTALLATION CONDITIONS. CONTACT FACTORY FOR ASSISTANCE.

Open the catalog to page 3