Catalog excerpts
vegaform evolution benefit performance of our PVD coated finishes in applications requiring hollow forming and deep pressing. vegaform evolution is a range of medium to soft temper, aluminium based, reflector materials produced from pre-anodized aluminium coated with special high reflectance PVD layers designed to provide high light output even after deep drawing operations. The high reflectance coatings are applied to coil and flat sheet products. vegaform evolution can be deformed using specially softned adapted pressing techniques and the coating technology employed allows the reflector...
Open the catalog to page 2Examples of reflective performance after pressing vegaform evolution vegaform evolution VFE95100 VFE95800 TR% = Total luminous reflectance (DIN 5036-3), El% = Elongation (%) * Base materials used in Almeco’s laboratories to perform reflectance tests on flat samples. Comparison of total reflectance values after deformation for high quality postanodising reflector material and vegaform evolution soft mirror 97,0 96,0 95,0 94,0 93,0 High quality postanodised reflector, bright anodised after streching 2,5 El% TR% = Total luminous reflectance (DIN 5036-3), SR60 = Specular reflectance at 60° (DIN...
Open the catalog to page 3vegaform evolution Mechanical properties Product Tensile strength Base Alloy Roll formed or press bent reflectors Shallow formed reflectors and reflectors sections with high specular finish Deep formed reflectors with mirror type finish Special deep formed reflectors sections Deep formed reflectors with bright matt finish Reflective properties of unformed sheet Total reflectance Total reflectance Diffuse reflectance 1° cone Diffuse reflectance 2.5° cone Specular reflectance 60° long Specular reflectance 60° trans ALMECO TEST
Open the catalog to page 4Environmental tests Temperature resistance Panels of vegaform evolution VFE95100 have been held at a temperature of 250°C for 7 days and no reduction in reflectance values or change in visual appearance was observed. In the case of hard rolled products there would be, of course, a softening of the aluminium after this treating but as vegaform evolution is already produced in a softened condition it is not so affected. Humidity tests In humidity tests, at 100% humidity at 38°C (ISO 6270-1), the evolution products show the same good resistance to deterioration as anodized aluminium. This has...
Open the catalog to page 5Almeco Group - Via della Liberazione, 15 20098 San Giuliano Milanese (MI) - Italy Ph.: +39 02.988963.1 - Fax: +39 02.988963.99 info.it@almecogroup.com - www.almecogroup.com Milan, Italy - Bernburg, Germany - Munich, Germany Goncelin, France - Atlanta, USA
Open the catalog to page 6All Almeco Group catalogs and technical brochures
-
LIGHTING REFLECTORS
15 Pages
-
ALMECO Solar
11 Pages
-
ALMECO Lighting
32 Pages
-
ALMECO Company Profile
23 Pages
-
LIGHTING vega daylighting
6 Pages
-
LIGHTING vegaled
2 Pages
-
LIGHTING vega
6 Pages
-
DECOR_bandoxaldecor_leaflet
2 Pages
-
LIGHTING vegaled on board
2 Pages
-
LIGHTING vegagreen
4 Pages
-
LIGHTING reflect+A team 2014
48 Pages
-
DECOR bandoxaldecor +
2 Pages
-
DECOR bandoxaldecor samples
6 Pages
-
SOLAR_vega_energy
8 Pages
-
SOLAR_TiNOX_energy
8 Pages
-
SOLAR_TiNOX_Artline
2 Pages
-
SOLAR_vegaenergy-ts
2 Pages
-
vega_prime
4 Pages
Archived catalogs
-
vegaflex
4 Pages