Aduro 6 / Aduro 6-5 / Aduro 6SK User Manual Ecolabel - Sintef 110-0283 - EN 13240 www.aduro.dk .Aduro

Good luck with your new wood burning stove! In order to get the best possible pleasure and benefit from your new Aduro wood burning stove, it is important that you read this User Manual thoroughly before you install your wood burning stove and start to use it. 1.0 General 1.1 Compliance Aduro 6 complies with the EN 13240 European standards, as well as the NS 3058 Norwegian standard and is thereby approved for installation and use in Europe. At the same time, the manufacturing process is subject to external quality control. The product documentation for Norway has Sintef number 110-0283 and can...

2.0 Mounting of soapstone Aduro 6SK is mounted with a soapstone cover. To avoid damages it is important to follow the following instructions: The soapstone parts are fixed with steel dowels. To remove the stones lift the one side of the top stone where after the side stone can be removed. It is important to hold the side stones as they otherwise will fall to the side. The side stone has to be lifted 2 cm before it can be removed from the stove. The soapstone can be mounted again when the stove is placed at its final position. 2.1 When smoke outlet at the back of the stove is requested If you...

If the wood burning stove is to be placed close to flammable material, such as a wooden floor or carpet, it must be placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the wood burning stove, and 15 cm on each side. 3.2 Pipe connection Aduro 6 leaves the factory with the flue outlet mounted on the top. If you require the flue outlet on the back, remove the round circle from the rear cover at the upper rear of the stove. The cover plate (that covers the rear outlet) should then be moved to the top outlet. The top outlet is finished with the plate that lies...

prevents environmental damage in the form of smoke and malodorous fumes and also reduces the risk of chimney fires. Well seasoned wood fuel is essential for correct use. Make sure your fuel is kept dry. If the fuel is wet, a large proportion of the heat will be used to vaporize the water, and this energy will disappear up the chimney. It is clearly not only uneconomical to fire with wet fuel but also, as mentioned above, increases the risk of producing soot, smoke and other environmentally damaging by-products. Burning varnished wood, impregnated wood, chipboard, paper and other waste is strictly...

During the first firing, which should be carried out using approximately 1 kg of wood, the stoking door must be left slightly open and must not be closed until the stove is cold. This is to prevent the sealing rope sticking to the stove. 4.5 How should I use my wood burning stove? The wood burning stove is intended for intermittent combustion. This means that each stoking should burn down to embers before new logs are added. In order to obtain the best possible combustion, you should regulate the effect/heat output with the fuel. Burning small logs provides more powerful combustion than burning...

4.8.1 How to operate Aduro-tronic When lighting When lighting a fire in the wood burning stove for the first time, the maximum amount of primary air will be needed to light the fire. For that reason, the primary damper can be kept "forcibly open". This is done by pulling the primary damper forward as far as possible and then fixing it with the Aduro Key (see illustration). When the stove is warm and a layer of embers has been created on the bottom of the combustion chamber, the Aduro-tronic can be set to the automatic position, i.e. the Aduro Key can be removed. Alternatively, you can leave the...

5.1 Inadquate draught in the chimney If the chimney is too short, leaks or is inadequately insulated, there may be problems with the chimney draught (let the chimney sweep assess this). The draught should be approx. 0.10-0.14 mbar in order to provide satisfactory combustion and prevent smoke leakage. If the chimney sweep judges the draught to be satisfactory, but you still have problems lighting a fire, try extending the fire lighting phase/using more thin pieces of kindling, so that the chimney gets thoroughly warm. The chimney will not draw at optimum effect until it is warm. The fire lighting...

Flue pipe Օ Gaskets and other spare parts 8.0 Product liability and warranty In accordance with the Danish Sale of Goods Act, product liability will exist for two years from the date of purchase of the wood burning stove. The dated receipt will be sufficient proof. Product liability will not cover damage caused by incorrect installation and use of the wood burning stove. Likewise, product liability will not cover loose parts and wear parts (fireproof tiles, glass, gaskets, rails, cast iron grate and control), as they are worn by ordinary use. These parts can be purchased as spare parts. 8.1 Free...