ADHESIVES FOR WOOD FLOORS MS GOLD FLEX HIGH-PERFORMANCE MONOCOMPONENT MS ADHESIVE Monocomponent silane adhesive specifically for gluing all types of wooden floors on cement-based sub-floors or on pre-existing non-absorbent floors (marble, tiles, flagstones, wood surfaces). TECHNICAL CHARACTERISTICS: • Monocomponent • 100% MS Technology • High yield • High initial tack • Suitable for gluing all types of wood flooring • Free from isocyanate and amines • Solvent-free • Low VOC emissions SPECIAL PROPERTIES: Symbol EC1 PLUS Established using GEV criteria, classified as EMICODE EC1 PLUS: very low emissions. Emission class as per French regulations. ADESIV S.R.L. WB MONO MS und WB MONO MS LE Zulassungsnummer Z-155.10-367 Emissiongeprüftes Bauprodukt nach DIBt-Grundsätzen Building product with emissions tested in accordance with the DIBt directive - glue for parquet. Z-155.10-367 Suitable for underfloor systems Reduction of footfall noise WHERE IT CAN BE APPLIED: - Absorbent and non-absorbent flooring - Traditional cement screeds - Anhydride screeds - Calcium sulphate screeds - Absorbent and non-absorbent subfloors with underfloor heating or cooling systems The following can be glued to these surfaces: - 10 mm non-locking solid wood elements (lamparquet) as per the DIN EN 13227 standard - mosaic parquet as per the DIN EN 13488 standard - (industrial) solid wood strips as per the DIN EN 14761 standard - M/F interlocking solid oak wood boards with a max. width 18 cm or 20 cm as per the DIN EN 13226 standard - multi-layer pre-finished floors as per the DIN EN 13489 standard - cork flooring as per the DIN EN 12104 standard If applied smoothly and evenly (forming a continuous layer), MS GOLD FLEX can act as a vapour seal barrier exclusively for the type of tongue-and-groove parquet floors indicated and on non-heated laying surfaces with residual humidity of up to 4%, corresponding to 85% air humidity. ADESIV S.R.L. Via delle Rose, 31 - 36061 Bassano del Grappa (VI) - ITALY Tel.: +39(0)424-566 406 - Fax: +39(0)424-566 473 - www.adesiv.it - E-mail: [email protected] ADESIV srl. guarantees that the information on this data sheet has been provided based on its experience and technical/scientific knowledge; however, ADESIV cannot accept any liability for the results obtained by using the products, because the conditions of application are beyond its control. It is always advisable to check the effective suitability of the product for each specific case. This version replaces and invalidates all pre

ADHESIVES FOR WOOD FLOORS SPECIFIC CHARACTERISTICS (normal conditions): PREPARING THE SURFACE The surface to be treated must be compact, clean and free from loose parts such as traces of wall paint, dust, wax and the like, and must be compliant with the DIN 18356 standard. Before laying, always check the humidity level of the sub-floor and the wood, using the appropriate instruments. The humidity of the sub-floor must be measured in depth (approx. 2-3 cm), using a CCM moisture tester in order to rule out the presence of particularly hygroscopic substances (such as pumice, vermiculite), which could...