Millennium Lockin? Pocket® Inter-Locking Flashing System
2Pages

Product Information Millennium Lockin’ Pocket® Inter-Locking Flashing System Description Millennium Lockin’ Pocket® Inter-Locking Flashing System is a pre-fabricated inter-locking pocket that is easily assembled on- site and filled with fast setting, solvent free, Millennium Hurricane Force® Universal Sealer that becomes waterproof within minutes of application. Millennium Lockin’ Pocket® are available in different packaging options. The pre-fabricated pockets simply connect with tongue and groove joints and are composed of a high strength, flexible polyurethane elastomer. All pieces are easily joined by a patent pending locking system to create a pocket of desired size. Basic Use Millennium Lockin’ Pocket® are designed to seal technically challenging roof penetrations where field flashing may not be practical. When installed and filled with Millennium Hurricane Force® Universal Sealer, the Millennium Lockin’ Pocket® Inter-Locking Flashing System becomes a long lasting, waterproof, solid mass that can make the most challenging penetrations watertight in minutes. Approved Membrane Substrates • Granule surfaced modified bitumen • EPDM • TPO • Metal • Smooth surfaced asphalt Built-up Roofs (BUR) • Gravel surfaced BUR (asphalt & coal tar pitch) For a complete list of approved substrates, or for additional information, contact our Technical Department. Requires no mixing, reduces labor costs Weather resistant Long lasting weather-tight seal Solvent free Remains flexible, absorbs stresses Compatible with most substrates Can be used on SBS, EPDM, TPO, BUR, & Metal Variety of sizes available Ability to flash most rooftop penetrations Safety Prior to working with this or any product consult product label and Material Safety Data Sheet (MSDS) for necessary health and safety precautions. Limitations • Do not apply to wet or damp surfaces. • Do not use grout or any other type of fillers. • Lockin’ Pocket® must be on a flat, level substrate, and is not intended for steep slope applications. Color Black Keep temperature of contents between 65°F-85°F (18°C-29°C) 24 hours prior to use. Do not store in direct sunlight or temperatures higher than 90°F (32°C). CAUTION: All statements and technical information in this document are based on tests or data that ADCO believes is reliable. However, ADCO does not warrant or guarantee the accuracy or completeness of this information. The user has sole knowledge and control of factors that can affect the performance of ADCO’s products in the user’s intended application. It is the user’s responsibility to conduct tests to determine the compatibility of ADCO’s product with the design, structure, and materials of the user’s end product and the suitability of ADCO’s product for the user’s method of application and intended use. The user assumes all risk and liability arising out of such use. P.O. Box 457, 4401 Page Avenue Michigan Center, MI 49254 Phone: (800) 248-4010 Fax: (517) 764-6697 www.adcocorp.com

Make sure substrate is clear of loose gravel, dirt, granules, or all foreign substances that can affect adhesion. Refer to Surface Preparation Guidelines. Place Millennium Lockin’ Pocket® in desired location and mark the outside edge for reference. Millennium Lockin’ Pocket® should be placed to assure at least one (1) inch clearance from the inside of the Millennium Lockin’ Pocket® and penetration. Penetrations should be prepared by wire brushing to remove loose cements, sealers, rust, or other contaminants that would prevent a positive seal. Seal base of penetration with Millennium LPS...