TAS
1 / 1ページ

カタログの抜粋

Technical Datasheet - Transitions, Covers & Ramps Aluminium Angle Edge - Self Adhesive - TAS Product Description This aluminium retro fit transition profile is incredibly easy to install without mechanical fixings, thanks to its self adhesive strip. The varying depths provide an easy solution of choice when bridging gaps and accommodating height differences in floor finishes. The TAS profile is very suitable for use with hard and smooth floor coverings. Dimensions and Colour Available in lengths of 2.7m and also is only available in Oak (40), Matt Silver (81) and Matt Brass (83) finishes. Technical Details Genesis Aluminium Profiles are available in different anodised finishes and powder coated finishes - All natural Aluminium (Mill Finish) has an oxide film of approx 0.2 microns, when Mechanically & Chemically polished the anodising process increases this to 5 microns, up-to 20 microns for the Matt finish and 100 for Powder coated. Genesis TAS profiles do not require any special maintenance. Oxidation films on Aluminium may be removed with a common polishing agent; however, they do reoccur. Damaged anodised finishes may only be repaired by re-coating. Aluminium must be tested to verify its suitability if chemical stresses are anticipated. Cementitious materials, in conjunction with moisture, become alkaline. Since aluminium is sensitive to alkaline substances, exposure to the alkali (depending on the concentration and time of exposure) may result in corrosion (aluminium hydroxide formation). Therefore, it is important to remove adhesive or grout residue from visible surfaces. In addition, ensure that the profile is solidly embedded in the setting material and that all cavities are filled to prevent the collection of alkaline water. The anodised layer creates a finish that retains a uniform appearance during normal use. The surface, however, is susceptible to scratching and wear and may be damaged by tile adhesive, mortar, or grouting material. Therefore, setting materials must be removed immediately. Otherwise, the description regarding aluminium applies. 1. Clean surface thoroughly ensuring removal of any contamination that may prevent the adhesion tape. NB it is important to remember that the safety strip will only stick to surfaces that are smooth and free form dirt and grease. 2. Cut to length, remove release paper from self-adhesive strip. 3. Place the profile into position, apply pressure along the full length to ensure adhesion. Do not attempt to re-position once the initial adhesion has taken place. Aluminium AA 6063 T6 / UNS A96063 anodised to DIN 17611 Si% 0.2-0.6 Fe% 0.35 Cu% 0.1 Mn% 0.1 Mg% 0.45-0.9 Zn% 0.1 Ti% 0.1 Cr% 0.1 Al Balance P.V.C. Trim • Stair Nosings • Movement Joints • Transitions • Entrance Matting• Edge Protection • Metal Profiles • Tactiles• Tools Litokol spa - via G. Falcone, 13/1 - Rubiera (RE) - Italy Tel.+39.0522.622811- info@litokol.it - w

カタログの1ページ目を開く

TAS 1 / 1ページ

カタログの抜粋

LITOKOLのすべてのカタログと技術パンフレット

TAS
1 / 1ページ