RAD
1 / 1ページ

カタログの抜粋

Technical Datasheet - Transitions, Covers & Ramps Aluminium Access Ramp - RAD Product Description Genesis RAD is a profile with an adjustable arm for creating transitions between floor coverings of different heights; e.g. the transition between tile and carpet while protecting the edges of adjacent coverings. Suitable for commercial entrances, showrooms and high traffic areas. Dimensions and Colour RAD is available in 2.5m lengths, Matt Silver (81) finish. Technical Details Genesis Aluminium Profiles are available in different anodised finishes and powder coated finishes - All natural Aluminium (Mill Finish) has an oxide film of approx 0.2 microns, when Mechanically & Chemically polished the anodising process increases this to 5 microns, up-to 20 microns for the Matt finish and 100 for Powder coated. Genesis RAD profiles do not require any special maintenance. Oxidation films on Aluminium may be removed with a common polishing agent; however, they do reoccur. Damaged anodised finishes may only be repaired by re-coating. Aluminium must be tested to verify its suitability if chemical stresses are anticipated. Cementitious materials, in conjunction with moisture, become alkaline. Since aluminium is sensitive to alkaline substances, exposure to the alkali (depending on the concentration and time of exposure) may result in corrosion (aluminium hydroxide formation). Therefore, it is important to remove adhesive or grout residue from visible surfaces. In addition, ensure that the profile is solidly embedded in the setting material and that all cavities are filled to prevent the collection of alkaline water. The anodised layer creates a finish that retains a uniform appearance during normal use. The surface, however, is susceptible to scratching and wear and may be damaged by tile adhesive, mortar, or grouting material. Therefore, setting materials must be removed immediately. Otherwise, the description regarding aluminium applies. 1. Ensure that the RAD profile depth (d) is correct for the flooring material. 2. Line up the RAD profile along the join between the two floor coverings and cut to length desired. 3. Press the perforated anchoring leg of the RAD onto the floor and align, mechanical fix if required or simply push into the floor covering adhesive allowing this to perforate the flange of the profile. 4. Use additional adhesive over the perforated anchoring leg to ensure full coverage if necessary. 5. Solidly embed the tiles so that the tiled surface is flush with the top of the profile. The profile should not be higher than the tiled surface, but rather up to approximately 1 mm lower. 6. Fill the joint completely with grout. Aluminium AA 6063 T6 / UNS A96063 anodised to DIN 17611 Si% 0.2-0.6 Fe% 0.35 Cu% 0.1 Mn% 0.1 Mg% 0.45-0.9 Zn% 0.1 Ti% 0.1 Cr% 0.1 Al Balance P.V.C. Trim • Stair Nosings • Movement Joints • Transitions • Entrance Matting• Edge Protection • Metal Profiles • Tactiles• Tools Litokol spa - via G. Falcone, 13/1 - Rubiera (RE) - Italy Tel.+39.0522.622811- info@litokol.it - w

カタログの1ページ目を開く

RAD 1 / 1ページ

カタログの抜粋

LITOKOLのすべてのカタログと技術パンフレット

RAD
1 / 1ページ