カタログ >
Kent Stainless >
Kent Diamond Tactile Warning Stud

Kent Diamond Tactile Warning Stud
1 / 7ページ

カタログの抜粋

Kent Diamond Tactile Warning Stud

vjl KENT STAINLESS: STREET FURNITURE KENT DIAMOND TACTILE WARNING STUD (KDTWS 35) Specify: Kent Diamond Tactile Warning Stud (KDTWS 35); Grade 316 Stainless Steel; Dia: 1.37" (35mm), Height: 0.19" (5mm) ; 1nr 0.23" (6mm) dia x 0.59" (15mm) high studs, Polished Finish; Description: Kent Diamond Tactile Warning Stud provides an underfoot warning to identify hazards and dangerous areas where there is a change in levels or where there is an unprotected opening such as open stairwells and platforms. The stainless steel material is ideal for high-traffic pedestrian areas. The slip resistant...

カタログの2ページ目を開く

KENT STAINLESS: STREET FURNITURE KENT DIAMOND TACTILE WARNING STUD (KDTWS 35) Product Code Diameter Height Kent Diamond Tactile Warning Stud KDTWS 35 1.37" (35mm) 0.19" (5mm)

カタログの3ページ目を開く

KENT STAINLESS: STREET FURNITURE 3 KENT DIAMOND TACTILE WARNING STUD (KDTWS 35) Step 1: Drill x1, 0.39” (10mm) Diameter hole 0.86” (20mm) deep. Step 2: Clean out the drilled hole. Step 3: Fill with chemical mortar (Kent Stainless recommend MIT-SE Mortar). Step 4: Insert the Kent Diamond Tactile Warning Stud and leave to set for 24 hours

カタログの4ページ目を開く

KENT STAINLESS: STREET FURNITURE 4 KENT DIAMOND TACTILE WARNING STUD (KDTWS 35) Specify Choose your steel: Grade 304 Stainless steel Grade 316 Stainless steel Specify: Kent Diamond Tactile Warning Stud (KDTWS 35); Grade 316 Stainless Steel; Dia: 1.37” (35mm), Height: 0.19” (5mm); 1nr 0.23” (6mm) dia x 0.59” (15mm) high stud, Polished Finish;

カタログの5ページ目を開く

KENT STAINLESS: STREET FURNITURE KENT DIAMOND TACTILE WARNING STUD (KDTWS 35) Clean the stainless steel components using warm water with a mild detergent with a nonabrasive cloth or sponge. Heavier stains may require the use of a nylon-scouring pad or a stainless steel cleaner. To remove paint or graffiti use a cloth and Alkaline or solvent paint strippers according to type of paint. In the case of a bead blasted finish, where abrasive cleaning is required, always use a random circular rubbing action with a cloth. In the case of brushed finishes the surface consists of uniform fine...

カタログの6ページ目を開く