カタログ >
Ancon Building Products >
Staifix QuickStart Wall Starter System

Staifix QuickStart Wall Starter System
1 / 2ページ

カタログの抜粋

Staifix QuickStart Wall Starter System - 1

QuickStart Wall Starter This stainless steel system includes all wall ties and fixings to join a single skin of masonry, 2400mm high, to an existing wall. Integral fold-down wall ties are fast and simple to install and can help maintain an accurate masonry gauge. Each pack contains: • 2 x Starter strips (10 integral wall ties) • 1 x Fixings pack (5 screws, 5 plugs, 5 washers) Suitable for: • Brickwork and blockwork • Single leaf and cavity walls • Internal and external walls • Wall widths from 60mm to 250mm The design shear strength of the system is 4.3kN for a wall height of 2400mm, when fixed to one of the following materials: solid clay bricks; solid dense or lightweight aggregate concrete blocks; solid aerated concrete blocks with a minimum crushing strength of 3.5N/mm2. Tel: 0114 238 1 238 Email: info@ancon.co.uk www.ancon.co.uk Manufactured by Meets the technical requirements of the

カタログの1ページ目を開く

Staifix QuickStart Wall Starter System - 2

QuickStart Wall Starter Installation Guide Equipment required: Spirit level, drill with 10mm masonry bit, 10mm spanner/socket, protective gloves and head/eye wear. Prior to installation Remove render, debris etc from existing wall where new wall will join. Figure 1 Mark the position of the five fixing holes following the guidance below: • Position vertically by folding down the bottom wall tie so it will sit in the required horizontal mortar joint, normally either the third brick course or first block course • Position horizontally by ensuring the wall starter will be central to the new...

カタログの2ページ目を開く