LIGHTTOOLS

L-TOOLS blank section, ceiling-bearing L-TOOLS end-plate set, ceiling-bearing L-TOOLS through-wiring with sockets L-TOOLS feed-in/feed-out unit for through-wiring

Cat. no. W/Hkg Order no.

Blank section unit,with flange (unas-sembled) • For cutting to suit on site (minimumlength 800 mm!) and subsequent assembly to a shortened U-section• Design otherwise as in L-TOOLS section,with flange• Incl.2 end plates with flange,for clo-sure of entire channel end• 1 end plate with fixed 7-pole terminalfor feed-in• Colour:titanium•Width of ceiling cut-out 124 mm,resulting aperture 100 mm

Blank channel section,ceiling-bearing

Length 1,600 mm 134/1757.7 60 210 006

Generally,one blank section is needed at the end of a length of channel and is cut to suit onsite.See formula for determining number of channel sections required on page 16.

Cat. no. kg Order no.

End caps with flange

End-cap set

• For closing both front ends of a ceil-ing-bearing channel length• 1 end plate with fixed 7-pole terminalfor feed-in• Material:extruded aluminium section • Colour:titanium

2 off,with flange 0.3 60 210 007

Only to be ordered if no blank channel sections are used.Therefore required if channel lengthis made up only of standard lengths 1,600 / 800.

Cat. no. kg Order no.

Through-wiring

7 x 1.5 mm

2

through-wiring

• 5 x 1.5 mm

2

für 3-circuit mains supply• 2 x 1.5 mm

Section with total length of approx. 1.6 m 0.4 60 210 010 Loom with total length of approx. 10 m 2.0 60 210 009
2

for bus supply• Incl.7-pole plug-in sockets every 320 mm• Fitted in channel section without useof tools• Through-wiring has to be cut tolength on site

Loom with total length of approx. 25 m 5.0 60 210 008

One additional feed-in/feed-out unit (also as closure) required per end of cut.

Cat. no.Order no.

Feed-in/feed-out unit for through- wiring • Connected on site to ends of through-wiring• For terminating continuous throughwiring or for safe closure of cable end• Plug-in contacts with push-buttonrelease• Feeder cable inserted through open-ing in end-plate

Feed-in/feed-out units (pair)

7-pole 60 210 011

To specify e.g.:L-TOOLS cut-to-length section,ceiling-bearing Length 1,600 mm 60 210 006