LIGHTTOOLS

LIGHTTOOLS section ceiling thicknesses (12.5/15.0/20.0 and 25.0 mm). withoutflange for “flush-mounting” insmooth, flat ceilings. Four frame types are available for four

Cat. no. W/Hkg Order no.

Section unit,without flange

Channel section,flush mounting

• 3 extruded aluminium sectionsassembled to form a U-shaped unit, side sections without flange• For recessing into flat plaster ceilingsor similar• Only in combination with mountingframe run-in with plaster• No-tool fitting of through-wiring • Incl.snap-on clips,for fixing butt jointto next channel section• Colour:titanium•Width of ceiling cut-out 121 mm,resulting aperture 100 mm

Length 1,600 mm 108/1755.9 60 210 001 Length 800 mm 108/1753.0 60 210 002

See formula for determining number of channel sections required on page 16.

L-TOOLS blank section, flush mounting L-TOOLS section, flush mounting

Cat. no. W/Hkg Order no.

Bank section unit,without flange(unassembled)

Blank channel section,flush mounting

Length 1,600 mm 108/1755.9 60 210 003

• For cutting to suit on site (minimumlength 800 mm!) and subsequent assembly to a shortened U-section• Design otherwise as in L-TOOLS sec-tion,flush mounting• Incl.2 end plates,for closure of entirechannel length• 1 end plate with fixed 7-pole terminalfor feed-in• Colour:titanium•Width of ceiling cut-out 121 mm,resulting aperture 100 mm

Generally,one blank section is needed at the end of a length of channel and is cut to suit onsite.See formula for determining number of channel sections required on page 16.

To specify e.g.:L-TOOLS section,flush mounting Length 1,600 mm 60 210 001