Text version of the page 
Installation
LIGHTTOOLSINSTALLATION 17 Efficient, precise, clean ...
Ceiling cut-out:Approx. 124 mm wide
Length - length of section + 14 mm supporting edges of the plasterboard panels in the ceiling cut-outmust be unobstructed over a width of approx. 20 mm, so that
the mounting frame rests cleanly on them to ensure a straight,flush fit. channelsection
Ceiling cut-out:Approx. 121 mm wide
Length – length of section + 26 mm
Distance between upper edge of suspended and structural
ceiling: First measure up and prepare the ceiling cut-out . The exact di-mensions and details depend on the way the section is fitted
(“flush-mounted” or “ceiling-bearing”. When flush-mounted, the from twosteel cords and usethem to level it.Place the ceilingpanels at the sidesover the edges of the channel section.METHOD 2: Insertthe
...flush-mounted ... ceiling-bearing
Insert the mounting frame complete with end plate into the cut-out and rest it on theceiling panels. Attach steel cords to brackets,
tension slightly and later pull upwards to precise height. Screw-fasten the supportingfins roughly every 10 cm from below through
the ceiling panels. Insert further frames,
connect the joints and tighten the screws. Fitthe second end plate. Plaster the joints andfinish off the ceiling.
Run the channel section into the ceiling cut-out already attachedto the cord and usethe cord to pull itupwards.
at least 180 mm Push the first channel section fitted with an endplate into theceiling cut-out and snap it into
the mounting frame. Tighten thebolts of the brackets. Offer upthe next section and connect
the joint with two springs, finally
insert the second end plate.
Click the connected through-wiring directly into the channel section, click itinto place and connect to the feeder. If required, insert plastic
trims into the channel section in order to conceal the wiring. Con-nect the lighting inserts to the phase selector plug as required. lighting inserts into the channel section in therequired position. “Empty” channel lengths can be blanked off by
using an aluminium cover section. This creates a clean, flush, un-obtrusive look with attractive lines. In order to obtain additionallighting effects, it is possible, if required, to provide the cover plate
with light slits or, for example round openings which can be
backed by coloured strips and backlit by lighting inserts fitted withT16 lamps.
METHOD 1: Sus-pend the