REFRIGERATION
Bottom-Mount & Side-by-Side
BCDEF90°110°130°90°110°130°
25
1 /
8 "
A A Bottom-Mount36" Model : 36
1 /
4 "Side-by-Side42" Model : 42
ABCDEF 1 42
"
413817
1 /
2 23
1 /
4 42
9 /
16 4748
/
4 "48" Model : 48
1 /
4 "
A 36" Model : 35
Trim Edge Side to Side "
43
1 /
2 4019
3 /
4 26
3 /
4 45
1 /
4 50
1 /
2 Overall Product DimensionsSpace Requirements**
Product DimensionsSide-by-Side ModelsDoor Design swing Dimensions
1 Mark studlocations onrear wall80"-90"above floor77" /
8 "23
1 /
2 "*83 83
1 /
4 " min.84
3 /
4 " max.to bottom ofsolid soffit
† 1 /
8 "24"Power
Cord
*3 AWidthHeight
1 /
2 "42" Model : 41
1 /
2 "48" Model : 47 6"
1 /
2 "
A*83
1 /
2 "
Required grounded electrical outlet location4"
6"6"11"3"23
1 /
2 "hole for plumbing can be located anywhere within shaded area
1 /
2 "
† *** CAPACITIESTotal (Cu. Ft.)Refrigerator (Cu. Ft.)Freezer (Cu. Ft.)Ice Bucket (lbs) 36" Non-Dispensing Model20.315.05.38 42" Non-Dispensing Model25.316.09.312.4 48" Non-Dispensing Model29.218.810.415 42" Dispensing Model25.216.09.211.4 48" Dispensing Model29.618.810.813.4 APPROXIMATE SHIPPING WEIGHT(lbs)Custom Panel ModelsStainless Steel Models 36" Non-Dispensing Model508548 42" Non-Dispensing Model563605 48" Non-Dispensing Model605646 42" Dispensing Model573613 48" Dispensing Model618659 GENERAL INFORMATION 115 Volts, 3 Prong Plug, 60 Hz, 6.5 Amps
Notes: 1) All height, width and depth dimensions are shown in inches. 2) Water line must provide 15-100 psi water pressure. Rough in water line before installing refrigerator. 3) Floor must support refrigerator (more than 600 pounds), contents and design door design panels. 4) The built-in refrigerator can be installed recessed in the design cabinet opening or at the end of cabinetsusing a side panel to enclose the refrigerator side.*Leg levelers extend 1/8 "below rollers; add 1 1/8 "for levelers fully extended 1 1/4 "below rollers. **Please refer to Installation Instructions manual prior to installation. InstallationInstructions are available at www.thermador.com. ***If a recommended water line location is used, no additional plumbing needs to be purchased. † If solid soffit is not available, see anti-tip requirements in the Installation Instructions manual. One of the three methods outlined in the installation instructions must be used.Specifications are correct at time of printing. Thermador reserves the right to change product specifications and design at any time, without notice. All refrigerators are UL and CUL approved. 18
For immediate critical installation dimensions by fax, use your fax handset and call (775)833-3600. Use code #8030 for a directory ofThermador ® products.