replacement of a broken part

Check the lower and upper piecesvisually to ascertain their condition. Note the location of the clips on the original piece. This allows you to draw the cutting area on the replacement product.Make sure the marking is correct. Theproduct must be cut for insertion into the cut out part of the Piterak® in the upper clip.Perform this operation on each sideof the Piterak®. The top clip replaces the standard clip. Insert the upper clip in the pro- file with the marking drawn previ- ously or keep the same fitting gauge measured with a shim under the standard clip.Insert the replacement product, firstinserting the upper part of the Piterak® until it contacts the product above, push towards the wall then exert downwards pressure to push the clips right in.

methods

grid T = width L +vertical joint Jvwidth L Specific edging (zinc, aluminium, window furniture frame...) to the limits of the area covered(water drainage in upper part) Vertical joint Jv Products recut vertically only

of gauging

Vertical limit of the area covered: running section (or angle section) offset Top clip gauge P= real height H + horizontaljoint Jh
height HHorizontal joint Jh Running clip External angles:Joining corner Piteraks, on angle tiles manufacturers Internal angles:joiningproductscut straight Terracotta productWeight-bearingaluminium sectionSpecific edging Specific trim (zinc, aluminium...) at the lower limits of the area covered: eventual use of standard anti-rodent features real width L
Realheight H Lower part: running clip masked by the product

> All the terracotta façade solutions

www.terrealfacade.com

109