INSTALLATION GUIDE PITERAK
® Use a laser or spirit level to draw thehorizontal line used as a start refer-
ence for fitting sections. The starting
point is determined according to the
installation grid.Mark out the area chosen for theprofiles according to the vertical
seal desired. Then strike the brackets
so as to drill the holes for inserting
the plugs. The brackets are set out
in a quincunx layout according to
the tile manufacturer section drawing (spacing to
be calculated).Install the end profiles and adjust theverticality. Adjust the verticality of the inter-mediate profiles.The starter clips are inserted from thelower point of the profile positioned
on the horizontal marker (2 self-tap-
ping screws/clip).A marking of the profiles is doneevery 10 mm for easier installation,
while preserving the evenness of
horizontal joints. Insert the Piterak®.Fasten each piece at the top with thetop clip using 2 self-tapping screws.Wall finished. edition No.6 2005 108