| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
| | | |
| | | replacement of a broken part | | |
| | | |
| | | FLish the top part back on one side to access the clip screw and remove it. Repeat this operation on the ot her side and recover the clips. Insert the clips on the replacement Maestral® | | Fbsition the running clips on the Offset the piece on one side so asto fas-replacement Maestral®) FUt the piece ten thevisbledip then repeat thisopera in position, first inserting the upper tion for the clip on the other side. part of the Maestral® until it is in contact with the piece above, push towards the wall then exert downward pressure to push the clips right in. | | |
| | | |
| | | |
| | | The replacement is complete. | | |
| | | |
| | | Specfic edging (zinc, auminium, window frame...) within the limits of the area covered (water dranage in the upper part) | | |
| | | grid T = width L + vertica joint Jv | | |
| | | Vertical sections for direct instaiation or cladding | | |
| | | methods of gauging | | |
| | | |
| | | |
| | | Angle clip recut | | |
| | | |
| | | |
| | | " gauge F = real I heght H + I horizonta joint Jh | | |
| | | Ange^ dip | | |
| | | |
| | | |
| | | - I vertica installation) | | |
| | | Externa anges: ange Maestra | | |
| | | |
| | | |
| | | Interna angles joining products cut straght | | |
| | | If | | |
| | | real width L | | |
| | | |
| | | |
| | | / | | |
| | | Specific edging (zinc aluminium... ) to the lower limits of the area covered: eventual use of standard anti-rodent features | | |
| | | ] Terracotta product I Aluminium section ■ Specific edging | | |
| | | |
| | | Angle cip recut | | |
| | | Low c i p (symmet ri ca ) | | |
| | | |
| | | |
| | | |
| | | |
| | | > All the terracotta façade solutions | | |
| | | www.terrealfacade.com | | |
| | | |
| | | |
| | | 97 | | |
| | | |
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |