Text version of the page 
INSTALLATION GUIDE MAESTRAL
® Use a laser or spirit level to draw thehorizontal line used as a start refer-
ence for inserting profiles. The start-
ing point is determined according to
the installation grid.Mark out the area chosen for theprofiles according to the vertical
joint desired. Verticality adjusted by
blocking, if necessary, to avoid
deforming the profile support. The starter clips are inserted from
the lower point of the profile posi-
tioned on the horizontal marker (2
self-tapping screws/clip).Place the clips running right and lefton the Maestral® and position the
profiles on the lower clips.Fix the clips against the core of theprofile using self-tapping screws
andaccording to the module (210
mm, 310 mm or 420 mm). Repeat the previous operation until
the desired height is reached: posi-
tion the running clips on the
Maestral®, insert it on the lower clips
and fasten one clip and then the
other. Position the upper clips for the lastMaestral®. Offset the side element so
that the visible clip can be mounted,
then repeat the operation for the
other upper clip.Position the Maestral® with the ver-tical joint desired. edition No.6 2005 96