replacing a broken part

Finish breaking the Zephir® so that it can be split into two separate parts. Each part can then be removed from its support. To replace it, about 4 mm must beremoved from the upper part of the Zephir®. Use a circular saw to cut the part of the Zephir® to be removed Before installing the Zephir®, add a stripof Sikaflex Pro 11 Fc mastic in the groove along the bottom edge of the Zephir® and on the lipped edge of the upper part.Position the Zephir® by first insertingthe upper part. The lower part will then rest on the lower elements. Replacement complete.

methods of gauging

grid T = width L +vertical joint Jv width LVertical joint Jv Horizontal cutout of a product under a strip (at least 2 strips maintained per product)Vertical cutout of a productRail offset in the lower part to be invisible Rail offset at the top to be invisible Rail installed on the strip nearest the cutout(at least 2 strips maintainedper product) Specific edging (zinc, aluminium, window furniture frame...) to the limits of the area covered(water drainage in upper part) Specific trim (zinc, aluminium...) at the lower limits of the area covered: eventual use of standard anti-rodent features standards longitudinal joints orcrossed joints
Realheight H gauge P= real height H + horizontal joint JhAltura AHorizontal joint Jh real width L Terracotta productAluminium railSpecific edging Primary framework (metal or wood)Centre distance between vertical uprights (primary framework): according to resistance to wind and impact requiredRail on the strip nearest the cutout Corner treatment:horizontal or vertical cutout Addition of anintermediate rail to increase wind and impact resistance Internal angles: joining product cut straightExternal angles:1/ joining products cut straight with strip cutouts2/ joining products bevelled3/ metal edging

> All the terracotta façade solutions

www.terrealfacade.com

75